Sears 917.38713 owner manual To Assemble and Attach Grass, Lower

TO ASSEMBLE AND ATTACH GRASS

CATCHER (See Figs. 3A thru 4)

°Insert leg of tubular frame through front opening of grass catcher and thread frame into sewn hem of bag

NOTE: Keep bag hem gathered on the straight leg of the tubular frame,

•When frame comes out the other end of sewn hem,

immediately work the end of frame down inside the bag as shown in inseL

oSlide sewn hem evenly around the tubular frame until

both ends of frame are exposed out of the front open- ing_

°Assemble lower frame to tubular frame as shown. Be

sure handle is outside of bag and frames are fully seated as shown in inset.

•Slip vinyl bindings over frame.

NOTE: If vinyl bindings are too stiff, hold them in warm

water for a few minutes. If bag gets wet, let it dry before using.

°Close the flip lid, Flip lid must be closed while operating lawn mower

Lift the rear door on the mower housing and place the grass catcher frame onto the formed tabs on the rear door hinge brackeL

The grass catcher is secured to the lawn mower

housing when the rear door is lowered onto the grass catcher frame,

CAUTION: Do not run your lawn mower without clipping deflector or approved grass catcher in place. Never attempt to operate the lawn mower with the rear door removed or propped open.

TUBULAR FRAME SEWN

SEWN HEM FLIP LID

BLY

LOWER

dr-/ I', _ // !1 (Framesmust

I

I

//J;

FIG. 3B

LOWER FRAME HANDLE

\

FIG, 3C

DOOR

BRACKET

GRASS

CATCHER

FRAME

FORMED

TABS

FIG. 4

FIG. 3A