Sears 917.251551 manual Il E, Engine, Lubrication, To Clean Battery and Terminals

Page 18

CUSTOM

BATTERY

Your tractor has a battery'charging system which is suffi- cient for normal use. However, periodic charging of the battery with an automotive charger will extend its fife,

Keep battery and terminals clean. o Keep battery bolts tight.

o Keep small vent holes open.

oRecharge at 6-10 amperes for 1 hour,

TO CLEAN BATTERY AND TERMINALS

Corrosion and dirt on the battery and terminals can cause the battery to "leak" power,

°Remove terminal guard,

°Disconnect BLACK battery cable first then RED bat- tery cable and remove battery from tractor_

oRinse the batter./with plain water and dry.

=Clean terminals and battery cable ends with wire brush until bright.

o Coat terminals with grease or petroleum jelly.

°Reinstall battery (See "CONNECT BATTERY" in the Assembly section of this manual).

IL E

TO CHANGE ENGINE OIL (See Figs. I4 and 15)

Determine temperature range expected before oil change,, All oH must meet AP1 service Ciassification SF or SGo

o Be sure tractor [s on level surface,

. Oil will drain more freely when warm.

o Catch oil in a suitable container.

oRemove oil fill cap/dipstick. Be careful not to allow dirt to enter the engine when changing oil,

oRemove drain plug.

oAfter oil has drained completely, replace oil drain plug and tighten securely_

Refill engine with oil through oil fill dipstick tube. Pour

slowly. Do not overfill. For approximate capacity see "PRODUCT SPECIFICATIONS" on page 3 of this manual.

Use gauge on oil fill cap/dipstick for chectdng level. Insert dipstick intothe tube and rest the oil fill cap on the tube, {3o not thread the cap onto the tube when taking reading Keep oil at"FULL" line on dipstick. Tighten cap onto the tube securely when finished.

ENGINE

LUBRICATION

Only use high quality detergent oif rated with API service classification SF or SG. Select the oil'sSAE viscosity grade according to your expected operating temperature,,

NOTE: Although multFviscosity oils (5W30, 10W30 etc.) improve starting in cold weather, these multi-visc6sity oils wilt result in increased oil consumption when used above 32°F, Check your'engine oil level more frequently to avoid possible engine damage from running low on oil,

Change the oil after the first two hours of operation and every 50 hours thereafter or at least once a year if the tractor is not used for 50 hours in one year.

Check the crankcase oil level before starting the engine and after each eight (8) hours of operation. Tighten oil fill cap/dipstick securely each time you check the oil level.

SAE VISCOSITY GRADES

°F

*20 °

0"

30 _

328 40 _

60 _

80_

100 _

°c-3oo-=o_ .10ooo _oo 2oo 3oo .oo

"TEMPERATURERANGEANTTClPATEDBEFORENEXTOILCHANGE'

FIG. 14

 

OIL DRAIN

AIR

PLUG

OIL FILL

SCREEN

CAPIDIPSTICK

 

FIG, 15

18

Image 18
Contents For Consumer Assistance HOT LINE, Call this Toll Free Number I1. Slope Operation Portant Safety precautionsGeneral Operation Iii. ChildrenLimited 90 DAY Warranty on Battery Maintenance AgreementProduct Specifications Customer ResponsibilitiesCustomer Responsibilities Assembly Operation 11-15Engine Maintenance PerformanceContents of Airidware Pack To Remove Tractor from Carton AssemblyTools Required for Assembly Before Rolling Tractor OFF SkidAccess Connect Battery See FigInstall Seat See Fig Check Tire PressureCheck Mower Levelness Install Mower and Drive Belt See FigsAssem LY For Proper Position ALLChecklist Operatio Knowyourtractor Operaon HOW to USE Your TractorTo Adjust Mower Cutting Height See To SET Parking Brake See FigTo Operate on Hills To Adjust Gauge Wheels See FigOperatson To TransportADD Gasoline To Start Engine See FigGeneral Recommendations Lubrication ChartCusto R Espons Before Each USETractor Blade Removal See FigCheck Transaxle OIL Level IL E BatteryTo Clean Battery and Terminals EngineCleaning MufflerSpark Plugs To Level Mower Housing Service AN AdjustmentsTo Install Mower TractorService a Adjustments To Replace Mower Drive BeltTo Adjust Brake See Fig Service and AdjustmentsTo Adjust Attachment Clutch To Replace Mower Blade Drive BeltServhce AN To Adjust Steering Wheel AlignmentFront Wheel TOE-IN Adjustment To Replace Motion Drive BeltTo Replace Headlight Bulb Servhoe and AdjustmentsTo Remove Wheel for Repairs Interlocks and RelaysADJ $TMENT$ To Remove Hood and Grill Assembly See Fig$.ERVICE AN See FigEngine To Adjust Throttle Control Cable See FigTo Adjust Choke Control See FigsService and Adjustments To Adjust Carburetor See FigFuel System StorageOther Engine OILProblem CauseCorrection Problem Cause Correction Trou Leshooting PointsTractor - Model Number SchematicEngine Connector UnitTractor -- Model Number ElectricalTractor --MODEL Number KEY Part DescriptionChassis and Enclosures REPAnR Parts Ground Drive 3836 355138 6156Repaurparts 138390Steering Assembly Tractor - Model Number 917,251551 KEY Part NO. noEngine Spark Arrester KITKEY Part NO. noSeat Assembly NOoKEY Tractor = Model NumberDecals Insert Strg1216 Lift AssemblyTractor Model Number 20 19Lift Assembly Mower Deck 222Tractor -=MODEL Number KEY PartTransaxle 3158887 Tractor - Model Number TransaxleUoS, inches Kohler Engine Model Number CV22 PS67515 14 151617Cylinder HEAD/VALVE/BREATHER KEY Part Description Crankcase KEY Part NO, noTractor - Model Number 917.25!551 20 19 18 17 13 tIGNITION/ELECTRICAL KEY Part NO. no Description Blower Housing & BafflesKohler Engine -MODELNUMBER CV22 PS67515 Not IllustratedStartingsystemi Part Description OIL Panilubrication KEY Part DescriptionStarting System Engine Controls KEY Part DescriptionTRACTOR-- Model Number Fuel System KEY Part NO, no CrankshaftExhaust KEY Part Otes Suggested Guide for Sighting Slopes for Safe Operation Model Number Engine Model NO. CV22-67515 If YOU Need Repair Service or PartsFor Repair SERVICE, Call this Toll Free Number Part Number Part Description