SERVICE AND
TO REMOVE MOWER (See Fig. 18)
=Place attachment clutch in "DISENGAGED" position.
-Turn height adjustment knob to lowest setting. = Lower mower to its lowest position.
Remove retainer spring holding
Remove retainer springs from suspension arms at deck and disengage arms from deck.
•Raise attachment lift to its highest position.
•Remove two retainer springs from each front link and remove links.
°Slide mower forward and remove belt from electric clutch pulley.
°Slide mower out from under right side of tractor.
IMPORTANT: IFAN ATTACHMENT OTHER THAN THE MOWER DECK ISTO BE MOUNTED ON THE TRACTOR, REMOVE THE FRONT LINKS.
TO INSTALL MOWER
Follow procedure described in "INSTALL MOWER AND DRIVE BELT" in the Assembly section of this manual.
ADJUSTMENTS
TO LEVEL MOWER HOUSING
Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See "PRODUCT SPECIFICATIONS" on page 3of this manual). If tires are over or underinflated, you will not properly adjust your mower.
•Raise mower to its highest position.
oAtthe midpoint of both sidesof mower, measure height
from bottom edge of mower to ground. Distance "A" on both sides of mower should be the same or within 1/4" of each other.
If adjustment is necessary, make adjustment on one side of mower only.
=To raise one side of mower, tighten lift link adjustment nut on that side.
-To lower one side of mower, loosen lift link adjustment nut on that side.
NOTE: Each full turn of adjustment nut will change mower height about 1/8".
Recheck measurements | after adjusting. |
BOTTOM EDGE | BOTTOM EDGE |
OF MOWER TO | OF MOWER TO |
GROUND | GROUND |
GROUND LINE
ADJUSTMENT |
| FIG. 19 |
NUTS | LIFT | FRONT |
| LINKS | SUSPENSION |
SUSPENSION
ARMS
BRACKET
CHASSIS
FRONT
SUSPENSION
BRACKET
//
RETAINER
SPRINGS
RETAINER
SPRING
FRONT MOWER BRACKET
BARRETAINER
FIG. 18
2O