AIR CLEANER COVER _"_ | |
SCREW _, |
|
k |
|
BLOWER |
|
HOUSING | SCREW% |
SCREW |
|
HEX HD
SCREW
COOLING
HEX HD FINS
SCREW
CYLINDER
HEAD N
COVER
PLUG
FIGURE 29
3.CLEAN ENGINE COOLING FINS
Keep Engine Cooling Fins free of dust, dirt and oil to pre- vent Engine damage from overheating.
a. Snap Cover off Air Cleaner (Fig. 29L Remove Hex Head Screw from inside Air Cleaner. Remove two Slotted Head Screws from rear of Air Cleaner. Pull Air Cleaner'off.
b, Remove two Hex Head Screws from front of Blower Housing_ Remove two Hex Head Screws from side of Blower Housing_
co Pull Blower Housing off.
Cytinder Head Cover may also be removed° Clean Engine
Cooling Fins with a stiff bristled brush or compressed air'_.
WEAR SAFETY GLASSES IF USING COM-
PRESSED AIRo
d.To reassemble, reverse above procedure,
NOTE: PRESS BREATHER TUBE INTO BOTTOM OF
AIR CLEANER (FIG. 29).
4.MUFFLER
Do not operate the tractor without a Muffler or tamper with the exhaust system_
DO NOT TOUCH HOT MUFFLER, CY-
LINDER OR FINS AS CONTACT MAY
CAUSE BURNS,
Periodically clean the muffler area to prevent grass, dirt
and combustible material from accumulatingo Damaged Mufflers or spark arresters could create a fire hazard,, In,,
spect periodically and replace if necessary,, tf your engine is equipped with a spark arrester screen assembly, remove
every 50 hours for cleaning and inspection,, Replace if damaged°
fv=.v t]@@.oo.s
1. REPLACE SPARK PLUG
Change the spark plug after every 100 hours of operation or at the beginning of each mowing season° A Deep Well 13/16 _ socket is required to remove the Spark Plug. Set
the Spark Plug gap at =030 inch (Fig, 30).
FIGURE 30