Height Adjustment

1.,Turn the main fuel adjusting needle out (counter- clockwise) from the prefiminary setting until the engine speed decreases (rich).

2,.Now turn the adjusting needle in (clockwise),,

The engine speed may increase, then it will decrease as the needle is turned in (lean),

3.,Now set the adjusting needle midway between the rich and lean settings,,

eJ Idle Speed Settin_":g Place the throttle control into the "idle"or "slow 'position° Set the iclle speed to

1200 rpm adjusting screw in or out.,

Idle Fuel Needle Setting: Place the throttle into the "idle" or "slow" position.

1_Tum. the idle fuel adjusting needle out (counter- clockwise) from the prefiminary setting until the engine speed decreases (rich),

2,,Now tum the adjusting needle in (clockwise). The engine speed may increase, then it will decrease as the needle is turned in (lean).,

3,,Set the adjusting needle midway between the rich and lean settings,,

4, Recheck the idle speed. Readjust the speed as necessary,,

4, Fuse Replacement

Repface with 3O amp automotive4ype plug in fuse Fuses can be purchased at all Sears Service Centers and most retail stores. Fuse is located directly behind dash.

5.Hood Removal

a.Lift hood Disconnect headlight wiring connection (Fig,.

32).

b, Unscrew one screw at rear of each side panel (Fig 31) ,

cPivothoodandsidepanefforwardandliftofftractor(Fig,,

32)

d, To replace, reverse above procedure

6. Mower Adjustment

Adjust the mower while tractor is parked on level ground or driveway Make sure tire pressures are I Kg!cm 2 (I4 PSI) in front and O.7I Kg/cn'P (I0 PSI) in rear ff tires are o vet or under inflated, you wilt not properly adjust your mower

FOR ANY ADJUSTMENTSINSPECTION OR MAINTENANCE:

t PUSH TRACTOR CLUTCH BRAKE PEDAL

COMPLETELY INTO "BRAKE' POSITION

2MOVE GEAR SHIFT LEVER TO "N" (NEUTRAL)

POSITION

3	PLACE		PARKING		BRAKE		1N	ENGAGED
	POSITION		REMOVE			FOOT	FROM		PEDAL
4,	PLACE		ATTACHMENT			CLUTCH		SWITCH		1N
	'DISENGAGED			POSIT1ON
5	TURN	IGNITION		KEY		TO '	OFF	POSITION
6	MAKE		ABSOLUTELY			SURE	THE		BLADES
	AND	ALL MOVING			PARTSHAVE			COMPLET
	ELY	STOPPED
7	REMOVE		THE	IGNITION		KEY
8	DISCONNECT			THE	SPARK		PLUG		WIRE(S)
	FROM		THE	SPARK		PLUG(S)		AND		KEEP
	WIRE(S)		AWAY		FROM		THE		PLUG(S}
	TO PREVENT			INJURY		FROM ACCIDENTAL
	STARTING			BE	CAREFUL			TO	AVOID
	TOUCHING			HOT	ENGINE		OR	MUFFLER
	COMPONENTS

Adjustment for mower height ts made with the height adjust-

ment knob Raise mower cutting height by turning height

adjustment knob clockwise ( _ ) Lower mower cutting height by turning height adjustment knob counterclockwise

&ADJUSTMENT

:. ,k

SCREW

.=./

FIGURE 31

WIRE

CONNECTION

FIG URE 32

HEIGHT ADJUSTMENT

KNOB

FIGURE 33

LIFT L E V E R "-"-_

PLUNGER

LIF]' _

LEVER

SIDE TO SIDE

ADJUSTMENT

GROUND	GROUND
LEVEL	LEVEL

(_)	(Fig 33)	21	FIGURE 34