e. Connect RED battery cable to positive (+)
battery terminal with hex bolt, flat washer, lockwasher and hex nut (shown full size below)
found in bag of parts (Fig. 5).. Tighten securely. f. Connect BLACK ground cable to negadve
size belowj found in bag of parts (Fig. 5).. Tighten securely.
©©
NOTE IF YOU HAVE A WEAK BATTERY, SEE 'START-
ING YOUR TRACTOR WITH A WEAK BATTERY' (PAGE 20)
g.Using the square hole on one side of the battery support (Fig. 6) insert one battery bolt, head of bolt down.. Fasten the battery bolt to the terminal guard using wing nut as shown (Fig.. 6). Bolts, nuts, and terminal guard, shown below, are found in bag of parts.
hAssemble the remaining battery bolt to other side of battery support and fasten terminal guard to it with remaining wing nut.. Tighten both wing nuts securely (by hand)) at the same time (Fig 6).
WASHE R | HEX |
i | BOLTS |
BATTERYBLACK
TERMINAL(NEGATIVE)
_///./ ' CABLE
DRAIN | TU |
|
{ON LEFT |
| |
REAR | SIDE) | FIGURE 5 |
| ||
WING
NUT
WiNG NUT
J
//"
TERMINAL DOORS
t. Replace air intake duct (Fig 4). Make sure bottom lip of duct sits between battery and lip of battery tray.
j. Remove plastic from tractor hood and close
NOTE: USE TERMINAL ACCESS DOORS(FIG 6) FOR: 1 INSPECTION FOR SECURE CONNECTIONS
(TIGHTEN HARDWARE)
2 INSPECTION FOR CORROSION
3 TESTING BATTERY
4 ,JUMPING (IF REQUIRED)
5 CHARGING(IF REQUIRED)
KEEP TERMINAL ACCESS DOORS CLOSED WHEN NOT IN USE
DO NOT START ENGINE UNTIL MOWER
SUSPENSION BRACKET HAS BEEN
INSTALLATION, PAGE 10,,
BATTERY
BOLT
f
SQUARE
HOLE
TERMfNAL
GUARD
TERMINAL
ACCESS DOOR
FIGURE 6