10.Insert the ends of the lines through exit holes in the sides of the cover.
Line exit hole
Cover
11.Reinstall the spool and cover onto the trimmer head. Push until cover snaps into place.
REPLACING THE TRIMMER HEAD
1.Hold the dust cup with a wrench to keep the shaft from turning while removing and installing trimmer head.
Dust Cup
2.Remove trimmer head by turning counter- clockwise (looking from bottom of unit).
3.Thread replacement trimmer head onto the shaft by turning clockwise. Only tighten hand tight!
CARBURETOR IDLE SPEED ADJUSTMENT
WARNING: Keep others away when making idle speed adjustments. The trimmer head or any optional attachment will be spin- ning during most of this procedure. Wear your protective equipment and observe all safety precautions. After making adjustments, the trimmer head or any optional attachment must not move/spin at idle speed.
The carburetor has been carefully set at the factory. Adjustments may be necessary if you notice any of the following conditions:
S Engine will not idle when the throttle is released.
S The trimmer head or any optional attachment moves/spins at idle.
Make adjustments with the unit supported so the cutting attachment is off the ground and will not make contact with any object. Hold the unit by hand while running and making ad- justments. Keep all parts of your body away from the cutting attachment and muffler.
To adjust idle speed:
Allow engine to idle. Adjust speed until engine runs without trimmer head or any optional at- tachment moving or spinning (idle too fast) or engine stalling (idle speed too slow).
S Turn idle speed screw clockwise to increase engine speed if engine stalls or dies.
STurn idle speed screw counterclockwise to decrease engine speed if trimmer head or any optional attachment moves or spins at idle.
WARNING: Recheck the idle speed after each adjustment. The trimmer head or any optional attachment must not move or spin at idle speed to avoid serious injury to the operator or others.
16