Sears 917.25148 manual Connect Battery See Fig, Bed

,,, =........................................

ASSEMBLY

CONNECT BATTERY (See Fig. 2)

	nals.	Before	connecting	battery, re-
_	move	metal	bracelets,	wristwatch
	CAUTION: Do not short			battery termi-
	bands,	rings,	etc,

Positive terminal must be connected first to prevent sparking from acciden- tal grounding,

o Lift hood to raised position.

•Open terminal access doors, remove terminal protec- tive caps and discard.

•If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at 6-10 ampso

INSTALL SEAT (See Fig. 3)

Adjust seat before tightening adjustment knob

o Remove cardboard packing on seat pan

•Place seat on seat pan and assemble shoulder bolt.

•Assemble adjustment knob and flat washer loosely. Do not tighten.

o Tighten shoulder bolt securely

o Lower seat into operating position and sit on seat.

oSlide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down°

oGet off seat without moving its adjusted position.

. Raise seat and tighten adjustment knob securely.

=First connect RED battery cable to positive (+) battery terminal with hex bolt, flat washe r, lock washer and hex nut as shown Tighten securely,

oConnect BLACK grounding cable to negative (-) battery terminal with remaining hex bott, flat washer, lock washer and hex nut, Tighten securely_

o Close terminat access doors

SEAT

SEAT PAN X

SHOULDER _'X

Use terminal access doors for:

oInspection for secure connections (to tighten hard- ware),

oInspection for corrosion

• Testing battery,

o Jumping (if required),

.	Periodic charging.						ADJUSTMENT
							KNOB
			LOCK		FLAT		FIG. 3
	HEX NUT		WASHER		WASHER
	DISCARD TERMINAL	X	.	.	/	HE×

TERMINA.....i	;
AccEss _	i i i_t;_
DOOR _ _.i:,	-i _

(BED)

j* BLACK)

CABLE

FIG, 2