Sears 917.25147 owner manual Transaxle Shifter Linkage and AD, Justment See Figs

Page 23

RVICE AND ADJUSTMENTS

TRANSAXLE SHIFTER LINKAGE AND AD-

JUSTMENT (See Figs. 23 and 24)

The transaxle should be in neutral when the gear shift lever _sin the neutral (N) (lock gate) position. The adjustment _s oreset at the factory; qowever, if adjustment is needed 3roceed as follows:

Make sure transaxle is in neutral fN/.

Loosen two Iocknuts on tie rod.

Turn center rod until gearshift lever fails into neutral ock gate on fender console.

Tighten Iocknuts secure y.

TO REMOVE WHEEL FOR REPAIRS (See Fig. 25)

Block up axle securely.

={emove axle cover, retaining ring and washers to allow wheel removal [rear wheel contains a square key - Do not ioseL

Repalr tlre and reassemble

On rear wneels only: align grooves rn rear wheel hub ana axle, nsert square Key.

Replace washers and snap retaining nng securely n axle groove.

Reelace axle cover.

r.....-.,---GEARSHIFTLEVER

WA£;!ERS

RETAINING

LOCKGATERING

\

\

NEUTRAL

FIG. 23

AXLE COVER

LOCKNUTS

SQUARE KEY

'REAR WHEEL ONLY)

FiG. 25

CENTER ROD

TO START ENGINE WITH A WEAK BATTERY

See Fig. 2{})

CAUTION: Lead-acid barfs,ties 9ener-

TIE ROD

ZZ_

TRANSAXLE

/

FiG. 24

ate explosive gases. Keep sparks, flame and smoking materials away from bat-

teries. Always wear eye protection wl-en around batteries.

!_ 'our battery is too weaK to star[ the eng qel it should "e

"ecnargea, I 'jumper cables" are useo for emergency starting, follow rn_s oroceaure:

MPORTANT YOUR TRACTOR S EQUIPPED WITH _,

12 VOLT NEGATIVE GROUNDED SYSTEM THE OTHER

VEHICLE MUST ALSO BE _' I2 VOLT NEGAq VE

GROUNDED SYSTEM DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES

TO ADJUST STEERING WHEEL ALIGNMENT

If steering wheel crossbars are not nonzonta (left to right when wheels are positioned stralgnt forward remove steer-

ing wheel and reassemble oer restructions in the Assembly section of this manual.

FRONT WHEEL TOE-IN/CAMBER

The front whee toe-in and cameer are not aulustab_e on your tractor. If damage nas occurrec to affect me front

wneel toe-in or camber contact your nearest authorized service cemer/aeuartment.

TO ATTACH JUMPER CABLES

Connect each end of me RED cable tc the POSITIVE

•- terminal of each batten,,, taking care not to shot1 agatnst cnassls

Connect one ena of the BLACK cable to the NEGA- TIVE - terminal of fui y charged battery.

Connect me omer end ot the BLACK cable [o good CHASSIS GROUND away from fuel tank and battery.

TO REMOVE CABLES REVERSE ORDER-

BLACK cable first from chassis and then from the fu{ly cnarged battery,

RED cable last from bOth u_,ttenes

23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents Model Number 917.251470 Ownersmanual RnFTZM aNReproductive harm Safe Operation Practices for Ride-On MowersII, Slope Operation Themodelandserialnumberswillbefound Maintenance AgreementLimited 90 DAY Warranty on Battery Customer ResponsibilitiesINDEX Performance Accessories and AttachmentsEngine Maintenance Contents of Hardware Pack Before Rolling Tractor OFF Skid Tools Required for AssemblyConnect Battery See Fig To Remove Tractor from CartonCheck Brake System AssemblyInstall Seat See Fig Check Tire PressureCheck Mower Levelness Install Mower and Drive Belt See FigsCheck for PRC2ER Position of ALL Belts Checklis T Lock OperationKnow Your Tractor To Move Forward and Backward HOW to USE Your TractorPeration To Transport Before Starting the EngineTo Operate Mower See Fig To Operate on HillsTo Start Engine See Fig Mowing TipsGeneral Recommendations Maintenance ScheduleLubrication Chart Customer ResponsibilitiesBlade Care BatteryTractor Brake OperationLUBRiCATiON EngineBelts Transaxle CoolingMuffler CleaningSparkplugs IN-LINEFUEL Filter See FigTo Remove Mower See Fig Service AdjustmentsTo Install Mower Both Front Links Must be Equal in Length Service and AdjustmentsTo Level Mower Housing To Replace Motion Drive Belt To Adjust Brake See FigTo Replace Mower Drive Belt To Remove Wheel for Repairs See Fig To Adjust Steering Wheel AlignmentTransaxle Shifter Linkage and AD Justment See FigsTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control See Fig Acceleration Test Preliminary SettingFinal Setting Engine OiL TractorOther Fuel SystemTroubleshooti Points Problem Cause CorrectionCorrection Problem CauseTractor = Model Number 9!7.251470 Schematic2O33 Tractor - Model NumberElectrical Description KEY Part NO. noChassis Tractor - Model Number 9!7.251470136813 Tractor = Model NumberChassis KEYDrive Tractor - Model NumberPart KEY KEYTractor -- Model Number 917,251470 Steering AssemblyKEY Part Description Steering AssemblyEngine KEY Part NO. NO. Description KEY Part Seat AssemblyTractor -- Model Number Part DecalsWheels & Tires NO. no3622 Seat121006X Mower LiftMower Deck Tractor -- Model NumberDESCRiPTiON KEY Part NO, no\..7 776291 2T,=eth f54Engine B&S Model Number 460777, Type Number 284 6634 Engine B&S Model Number 460777, Type Number642 535 165305 978 332 116A O8O2 Tractor = Model Number005 Omeonent dmenslons KEY PartMagnetron Service Note Sight and Hold this Level with SKY Line or Tree Only Ride UP and Down HillNot Across HiLL Sighting GuidePart Number Partription Owners ManualFollowing iNFORMATiON

917.25147 specifications

The Sears 917.25147 is a notable model within the realm of lawn care and outdoor maintenance, specifically recognized for its versatility and reliability as a garden tractor. Designed for both homeowners and gardening enthusiasts alike, this model has garnered a reputation for its efficient performance and user-friendly features.

One of the standout characteristics of the Sears 917.25147 is its powerful engine. Equipped with a robust 18.5 HP Briggs & Stratton engine, this tractor ensures ample power for a variety of tasks, from mowing the lawn to hauling lighter loads. The engine's design emphasizes durability and efficiency, providing consistent performance that can tackle even the most challenging terrains.

The cutting deck of the Sears 917.25147 is another feature that deserves highlighting. With a 42-inch cutting width, it is ideally suited for medium to large lawns. This size strikes a balance between efficiency and maneuverability, allowing users to make quick work of their mowing duties while still navigating through tight spaces and shrubs. The deck also features adjustable cutting heights, which range from one to four inches, giving users the flexibility to customize their mowing experience based on grass type and desired lawn appearance.

In terms of comfort and convenience, the Sears 917.25147 is designed with the user in mind. The high-back seat offers ample support for extended mowing sessions, while the ergonomic controls are easy to reach and operate. The hydrostatic transmission system contributes to a seamless driving experience, allowing users to easily adjust their speed without the need for frequent gear changes.

Another technological advancement in the Sears 917.25147 is its integrated cutting system, which helps ensure an even and clean cut. This feature not only enhances the aesthetic appeal of freshly mowed grass but also promotes healthier lawn growth by preventing scalping.

Moreover, maintenance has been made easier with accessible components that can be serviced without the need for specialized tools. The tractor's compact design also facilitates storage, making it a practical addition to any home or garden.

In conclusion, the Sears 917.25147 lawn tractor combines power, efficiency, and user-friendly features, making it an excellent choice for anyone looking to maintain their outdoor space with ease. Its blend of quality construction, technological enhancements, and comfort-focused design positions it as a reliable partner for gardening endeavors.
Top Page Image Contents