Sears 917.25147 owner manual To Adjust Brake See Fig, To Replace Mower Drive Belt

Page 22

ERVICE AND

TO REPLACE MOWER DRIVE BELT

MOWER DRIVE BELT REMOVAL (See Fig. 20) -

Park tractor on a level surface, Engage parking brake. Disengage attachment clutch control.

=Remove four screws from L.R. mandrel cover and remove cover.

•Roll belt over the top of L,H. mandrel pulley.

•Remove belt from engine pulley. Remove belt from idle_ "" "_"_,

•Remove any dirt or grass clippings which may have

accumulated around mandrels and entire upper deck surface.

Check Dnmary laler arm ang two idlers to see that they rotate freely,

MOWER DRIVE BELT INSTALLATION (See Fig. zO} - Install belt in both idlers. Make sure belt is _nDotn Delt keepers at the idlers as shown.

Install new belt onto engine eutley.

Roll belt nto upper groove of L.H. manure pulley.

Carefully check belt routing making sure belt is _nthe grooves correctly and inside belt keeeers Reassemble L.H. mandrel cover.

L.H.

SCREWS

ENGINE

MANDREL

IDLER

PULLEY

 

PULLEYS

 

COVER

PRIMARY

 

 

 

 

DLER ARM

 

MANDREL

MOWER

DRIVE

BELT BELT

KEEPERS

ADJUSTMENTS

WITH PARKING BRAKE ,ENGAGED"

NUT "A"

JAM NUT

DPERATING ARM

FIG. 21

TO REPLACE MOTION DRIVE BELT

(See Fig. 22)

Park the tractor on level surface, Engage parking brake. For assistance, there is a belt installation guide decal on DOttom side of left footrest.

Remove mower See "TO REMOVE MOWER" in this section of this manuaQ

Remove UDDer pelt Keeper.

Remove belt from stationary idler and clutching idler. Pull celt SlaCK toward rear of tractor. Remove belt

upwards from transaxle pulley by deflecting belt keep- ers.

Pull belt toward front of tractor and remove downwards from around on j_ne pulley.

Install new belt by reversing above procedure.

IMPORTANT: MAKE SURE UPPER BELT KEEPER IS POSITIONED PROPERLY BETWEEN LOCATOR TABS.

ENGINE*"'---..

I

 

PULLEY

 

CLUTCHING

TABS

IDLER

 

FIG. 20

TO ADJUST BRAKE (See Fig. 21)

Your tractor is eauiDeeo w_th an aojustaD_e DraKe sy _tem which Is mounted on the right side of the trar _axle

If tractor reaulres more than s_x _6)feet stopping u_stance at hign speed in highest gear. then brake must be adjusted.

Depress clurcn/DraKe eeua_ ana engage parking DraKe.

Measure alstance between brake operating arm ana nut "'A"on DraKe roa.

If distance _sother than 1-1/2'. loosen jam nut ana turn nut "A" umn alstance becomes 1-1/2". Retighten jam nut against nut "A".

Road test tractor for proper stopping distance as stated aeove Readfust if necessary. If stopping distance is st greater man s_x 6} feet in h_§'_estgear runner

maintenance is necessary Contact your nearest au- thorized service centeddeeartment

KEEPER

STATIONARY IDLER

TRANSAXLE

PULLEY

FIG. 22

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents RnFTZM aN Model Number 917.251470 OwnersmanualII, Slope Operation Safe Operation Practices for Ride-On MowersReproductive harm Customer Responsibilities Maintenance AgreementLimited 90 DAY Warranty on Battery ThemodelandserialnumberswillbefoundINDEX Engine Maintenance Accessories and AttachmentsPerformance Contents of Hardware Pack To Remove Tractor from Carton Tools Required for AssemblyConnect Battery See Fig Before Rolling Tractor OFF SkidCheck Tire Pressure AssemblyInstall Seat See Fig Check Brake SystemCheck for PRC2ER Position of ALL Belts Install Mower and Drive Belt See FigsCheck Mower Levelness Checklis T Operation LockKnow Your Tractor Peration HOW to USE Your TractorTo Move Forward and Backward To Operate on Hills Before Starting the EngineTo Operate Mower See Fig To TransportMowing Tips To Start Engine See FigCustomer Responsibilities Maintenance ScheduleLubrication Chart General RecommendationsBrake Operation BatteryTractor Blade CareTransaxle Cooling EngineBelts LUBRiCATiONIN-LINEFUEL Filter See Fig CleaningSparkplugs MufflerTo Install Mower Service AdjustmentsTo Remove Mower See Fig To Level Mower Housing Service and AdjustmentsBoth Front Links Must be Equal in Length To Replace Mower Drive Belt To Adjust Brake See FigTo Replace Motion Drive Belt Justment See Figs To Adjust Steering Wheel AlignmentTransaxle Shifter Linkage and AD To Remove Wheel for Repairs See FigTo Adjust Choke Control See Fig To Adjust Throttle Control CableTo Replace Headlight Bulb Final Setting Preliminary SettingAcceleration Test Fuel System TractorOther Engine OiLProblem Cause Correction Troubleshooti PointsProblem Cause CorrectionSchematic Tractor = Model Number 9!7.251470Electrical Tractor - Model Number2O33 KEY Part NO. no DescriptionTractor - Model Number 9!7.251470 ChassisKEY Tractor = Model NumberChassis 136813Tractor - Model Number DriveKEY Part KEYSteering Assembly Tractor -- Model Number 917,251470Steering Assembly KEY Part DescriptionEngine KEY Part NO. NO. Description Tractor -- Model Number Seat AssemblyKEY Part NO. no DecalsWheels & Tires PartSeat 3622Mower Lift 121006XTractor -- Model Number Mower DeckKEY Part NO, no DESCRiPTiON\..7 2T,=eth f54 776291Engine B&S Model Number 460777, Type Number 165 Engine B&S Model Number 460777, Type Number642 535 284 6634116A O 305 978 332Tractor = Model Number 8O2005 Magnetron KEY PartOmeonent dmenslons Service Note Sighting Guide Only Ride UP and Down HillNot Across HiLL Sight and Hold this Level with SKY Line or TreeFollowing iNFORMATiON Owners ManualPart Number Partription

917.25147 specifications

The Sears 917.25147 is a notable model within the realm of lawn care and outdoor maintenance, specifically recognized for its versatility and reliability as a garden tractor. Designed for both homeowners and gardening enthusiasts alike, this model has garnered a reputation for its efficient performance and user-friendly features.

One of the standout characteristics of the Sears 917.25147 is its powerful engine. Equipped with a robust 18.5 HP Briggs & Stratton engine, this tractor ensures ample power for a variety of tasks, from mowing the lawn to hauling lighter loads. The engine's design emphasizes durability and efficiency, providing consistent performance that can tackle even the most challenging terrains.

The cutting deck of the Sears 917.25147 is another feature that deserves highlighting. With a 42-inch cutting width, it is ideally suited for medium to large lawns. This size strikes a balance between efficiency and maneuverability, allowing users to make quick work of their mowing duties while still navigating through tight spaces and shrubs. The deck also features adjustable cutting heights, which range from one to four inches, giving users the flexibility to customize their mowing experience based on grass type and desired lawn appearance.

In terms of comfort and convenience, the Sears 917.25147 is designed with the user in mind. The high-back seat offers ample support for extended mowing sessions, while the ergonomic controls are easy to reach and operate. The hydrostatic transmission system contributes to a seamless driving experience, allowing users to easily adjust their speed without the need for frequent gear changes.

Another technological advancement in the Sears 917.25147 is its integrated cutting system, which helps ensure an even and clean cut. This feature not only enhances the aesthetic appeal of freshly mowed grass but also promotes healthier lawn growth by preventing scalping.

Moreover, maintenance has been made easier with accessible components that can be serviced without the need for specialized tools. The tractor's compact design also facilitates storage, making it a practical addition to any home or garden.

In conclusion, the Sears 917.25147 lawn tractor combines power, efficiency, and user-friendly features, making it an excellent choice for anyone looking to maintain their outdoor space with ease. Its blend of quality construction, technological enhancements, and comfort-focused design positions it as a reliable partner for gardening endeavors.
Top Page Image Contents