Weed Eater 530163440 Know Your Trimmer, ON/OFF Switch Choke, Primer Bulb, Before Starting Engine

1.Remove wing nut from shield.

2.Insert bracket into slot as shown.

3.Pivot shield until bolt passes through hole in bracket.

4.Securely tighten wing nut onto bolt.

	Slot
Shield
		Bracket
			Wing
Line Limiter Blade			Nut

KNOW YOUR TRIMMER

READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.

					Assist Handle
								Tube
									Trimmer
									Head
		ON/OFF	Throttle Trigger
Muffler
		Switch		Spark Plug
		Starter			Choke Lever		Shield
		Handle
					Primer Bulb				Line
					Fuel Mix				Limiter
									Blade
					Fill Cap
ON/OFF SWITCH						CHOKE
The ON/OFF switch is used to stop engine.						The CHOKE helps to supply fuel to the engine
Move the switch to the OFF position to stop en-						to aid in cold starting. Activate the choke by
gine.						moving the choke lever to the FULL CHOKE
PRIMER BULB						position. After the engine attempts to start, move
The PRIMER BULB removes air from the car-						the choke lever to the HALF CHOKE position.
buretor and fuel lines and fills them with fuel.						Once engine has started, move the choke lever
This allows you to start the engine with fewer						to the OFF CHOKE position.
pulls on the starter rope. Activate the primer
bulb by pressing it and allowing it to return to
its original form.
BEFORE STARTING ENGINE						mixed with a good quality synthetic 2-cycle
						air-cooled engine oil designed to be mixed at a
	WARNING: Be sure to read the fuel					ratio of 40:1. Poulan/Weed Eater brand
information in the safety rules before you						synthetic oil is recommended. Mix gasoline and
begin. If you do not understand the safety						oil at a ratio of 40:1. A 40:1 ratio is obtained by
rules, do not attempt to fuel your unit. Call						mixing 3.2 ounces (95 ml) of oil with 1 gallon (4
1-800-554-6723.						liters) of unleaded gasoline. DO NOT USE
FUELING ENGINE						automotive oil or boat oil. These oils will cause
						engine damage. When mixing fuel, follow
	WARNING: Remove fuel cap slowly					instructions printed on container. Once oil is
						added to gasoline, shake container momentarily
when refueling.						to assure that the fuel is thoroughly mixed.
This engine is certified to operate on unleaded						Always read and follow the safety rules relating
gasoline. Before operation, gasoline must be						to fuel before fueling your unit.

4