CLEAN AIR FILTER
A dirty air filter decreases the life and perfor- mance of the engine and increases fuel con- sumption and harmful emissions.
Always clean your air filter after 5 tanks of fuel or 5 hours of operation, whichever comes first. Clean more frequently in dusty condi- tions. It is advisable to replace your air filter with a new one after every 50 hours of opera- tion, or annually, whichever comes first.
To clean filter:
1. Remove the two screws and the air filter cover from the engine.
2. Remove air filter.
NOTE: Do not clean the air filter with gaso- line or other flammable solvent to avoid creat- ing a fire hazard or producing harmful evapo- rative emissions.
3.Wash the filter in soap and water.
4.Allow filter to dry.
5.Add 4 or 5 drops of oil to the filter.
NOTE: Do not soak air filter with oil.
6. Squeeze the air filter to distribute oil.
7. Reinstall air filter in housing.
8. Reinstall air filter cover.
CAUTION: Make sure air filter is fitted into the corners of the housing to keep dust from entering engine and causing engine damage.
Air Filter | Cover |
Cover
Screws
to spin after the engine stops or after the throttle trigger has been released. Make sure the blade has stopped coasting and discon- nect the spark plug before performing work on the blade.
WARNING: Wear protective gloves when handling or performing maintenance on the blade to help avoid injury.
Always replace a blade that is bent, warped, cracked, broken, or damaged in any other way. Never attempt to straighten and reuse a damaged blade. Use only specified replace- ment blade.
S The blade is reversible. When the cutting edge on one side becomes worn, turn the blade over.
SCheck blade for flatness periodically. Lay the blade on a flat surface to inspect for flat- ness. Throw away a blade that is not flat.
REPLACE SPARK PLUG
The spark plug should be replaced each year to ensure the engine starts easier and runs better. Set spark plug gap at 0.025 inches. Ignition timing is fixed, nonadjustable.
1.Twist then pull off the spark plug boot.
2.Remove and discard the spark plug.
3.Replace with Champion
4.Reinstall the spark plug boot.
Spark Plug Boot
Spark Plug
BLADE MAINTENANCE
WARNING: The blade will continue
BLADE REPLACEMENT
1. To remove the blade, insert a screwdriver |
|
into the hole in the gearbox; then, remove | Nut |
the nut, washer, and blade from the blade | Hole |
shaft. | |
| Flat sides |
| Washer |
| 3. Install the washer and nut; turn nut coun- |
| terclockwise on the blade shaft. |
| 4. Bind blade by inserting a screwdriver in to |
| the hole in the gearbox; then, firmly tighten |
Blade | nut with a wrench. |
|
2.Align the flat area of the blade opening with the flat side of the shaft. Place the new blade on the shaft.
8
CARBURETOR ADJUSTMENTS
Your carburetor is equipped with limiter caps. Damage will occur if you turn the needles be- yond the limiter caps. Carburetor adjustment is a complicated task. We recommend that you take your unit to an authorized authorized service dealer.