homeowner use, the muffler and spark arrest- ing screen will not require any service. After 50 hours of use, we recommend that your muffler be serviced or replaced by your Au- thorized Service Dealer.
Handlebar 
Screw
Bracket Cover
Mounting 
Bracket
CARTON CONTENTS
Check carton contents for the following:
Sbrushcutter
Shandlebar screws (2)
Sblade shield screws (4) S cupped washer
S large nut for installing blade S long hex wrench
S short hex wrench S bracket cover
S metal shield S plastic shield
S shoulder strap with warning S weed blade
S trimmer head (assembled on unit) S handlebar
S container of oil
Examine parts for damage. Do not use dam- aged parts.
NOTE: If you need assistance or find parts missing or damaged, call
It is normal for the fuel filter to rattle in the empty fuel tank.
Finding fuel or oil residue on muffler is normal due to carburetor adjustments and testing done by the manufacturer.
ASSEMBLY
WARNING: Always stop unit and dis- connect spark plug before performing any as- sembly procedures.
WARNING: Make sure your unit is properly assembled and all fasteners are se- cure.
TOOLS REQUIRED
S2 Hex wrenches (provided)
SAdjustable wrench or large pliers S Phillips screwdriver
ATTACHING THE HANDLEBAR
ASSEMBLY OF SHOULDER STRAP
WARNING: Proper shoulder strap and handlebar adjustments before starting the engine are required.
STry on shoulder strap and adjust for fit and balance before starting the engine or begin- ning a cutting operation.
SInsert your right arm and head through the shoulder strap and allow it to rest on your left shoulder. Make sure the danger sign is on your back and the hook is to the right side of your waist.
NOTE: A
S Adjust the strap, allowing the hook to be about 6 inches below the waist.
SFasten the strap hook to the clamp located between the trigger handle and the handle- bar clamp base and lift the tool to the oper- ating position.
CONFIGURING YOUR UNIT
You can configure your unit using a cutting head for grass and light weeds, or a weed blade for cutting grass, weeds, and brush up to 1/2 inch in diameter. To assemble your unit, go to the section for the desired configuration and follow the instructions.
ASSEMBLY INFORMATION - TRIMMER HEAD
TRIMMER
HEAD
DANGER: During blade usage, the barrier portion of the handlebar must be installed as shown to provide a barrier be- tween operator and the spinning blade.
SLocate the decal on the handlebar. This de- cal includes two arrows. Position the han- dlebar with the mounting bracket between these arrows.
SPosition the bracket cover over the handle- bar. Again make sure the handlebar is be- tween the arrows.
S Insert screws and hand tighten only. Be sure the handlebar is installed correctly; then, tighten each screw securely with the short hex wrench.
4
NOTE: Remove the blade and metal shield before attaching the plastic shield and trim- mer head. To remove blade, push in locking lever and hold. Rotate blade nut until the lock- ing lever falls into one of the grooves in the dust cup. Continue to hold the locking lever. This will keep the shaft from turning while loosening the blade nut. Remove blade nut by turning clockwise. Release locking lever. Remove both washers and blade. To remove metal shield, loosen and remove the four mounting screws. See ATTACHING THE METAL SHIELD and INSTALLING THE METAL BLADE for illustrations. Be sure to store all parts and instructions for future use.