Weed Eater 530088848 Troubleshooting Table, Cause, Remedy, Need Assistance?, Need Service Part?

Page 9
TROUBLESHOOTING TABLE

TROUBLESHOOTING TABLE

WARNING: Always stop unit and disconnect spark plug before performing any of the recommended remedies below other than remedies that require operation of the unit.

TROUBLE

CAUSE

REMEDY

Engine will not

S

Engine flooded.

S

See “Starting.”

start.

S

Fuel tank empty.

S

Fill tank with correct fuel mixture.

 

S

Spark plug not firing.

S

Install new spark plug.

 

S

Fuel not reaching carburetor.

S

Check for dirty fuel filter; replace.

 

 

 

 

Check for kinked or split fuel line;

 

 

 

 

repair or replace.

 

S

Carburetor requires adjustment.

S

See “Carburetor Adjustments.”

Engine will not

S

Carburetor requires adjustment.

S

See “Carburetor Adjustments.”

idle properly.

S

Throttle trigger screw too

S

Loosen screw.

 

 

tight.

 

 

Engine will not

S

Air filter dirty.

S

Clean or replace air filter.

accelerate,

S

Spark plug fouled.

S

Clean or replace spark plug; re-gap.

lacks power,

S

Carburetor requires adjustment.

S

See “Carburetor Adjustments.”

or dies under

 

 

 

 

a load.

 

 

 

 

Engine

S

Fuel mixture incorrect.

S

Empty fuel tank and refill with

smokes

 

Air filter dirty.

 

correct fuel mixture.

excessively.

S

S

Clean or replace air filter.

 

S

Carburetor requires adjustment.

S

See “Carburetor Adjustments.”

Line does not

S

Line improperly routed in head.

S

Check line routing.

advance or

S

Line improperly wound on

S

Rewind line tightly and evenly.

breaks while

 

spool.

 

 

cutting.

S

Line size incorrect.

S

Use only 0.080” (2 mm) dia. line.

 

 

 

 

 

Line welds

S

Line size incorrect.

S

Use only 0.080” (2 mm) dia. line.

onto spool.

S

Incorrect spool.

S

Replace with correct spool.

 

S

Line is being crowded against

S

Cut with tip of line fully extended.

 

 

material being cut.

 

 

 

 

 

 

 

Line pulls

S

Too little line outside of head.

S

Remove spool and pull 4 inches

back into

 

Line size incorrect.

 

(10 cm) of line outside of head.

head.

S

S

Use only 0.080” (2 mm) dia. line.

 

 

 

 

 

NEED ASSISTANCE?

Call 1-800-554-6723.

NEED SERVICE PART?

Contact your dealer.

ELECTROLUX HOME PRODUCTS NORTH AMERICA, Division of WCI Out- door Products, Inc., warrants to the original purchaser that each new Weed Eater! brand gasoline tool or attachment is free from defects in material and workmanship and agrees to repair or replace under this war- ranty any defective gasoline product or at- tachment as follows from the original date of purchase.

2 YEARS- Parts and Labor, when used for household purposes.

60 DAYS - Parts and Labor, when used for commercial, professional, or income produc- ing purposes.

30 DAYS - Parts and Labor, if used for rental purposes.

This warranty is not transferable and does not cover damage or liability caused by improper handling, improper maintenance, or the use of accessories and/or attachments not spe- cifically recommended by ELECTROLUX HOME PRODUCTS NORTH AMERICA for this tool. Additionally , this warranty does not cover tune-ups, spark plugs, filters, starter ropes, starter springs, cutting line, or rotating head parts that will wear and require replace- ment with reasonable use during the warranty period. This warranty does not cover prede- livery setup or normal adjustments explained in the operator ’s manual.

THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.

NO CLAIMS FOR CONSEQUENTIAL OR OTHER DAMAGES WILL BE ALLOWED, AND THERE ARE NO OTHER EXPRESS WARRANTIES EXCEPT THOSE EX- PRESSLY STIPULATED HEREIN.

SOME STATES DO NOT ALLOW LIMITA- TIONS ON HOW LONG AN IMPLIED WAR- RANTY LASTS OR THE EXCLUSION OR

9

Image 9
Contents Manuel de L’utilisateur Operator’s Manual Manual del OperadorBC2400 For Occasional Use Only Please do not return unit to retailerOPERATOR SAFETY FUEL SAFETY UNIT/MAINTENANCE SAFETYCUTTING SAFETY TRANSPORTING AND STORAGEASSEMBLY CARTON CONTENTSASSEMBLY OF SHOULDER STRAP CONFIGURING YOUR UNITASSEMBLY INFORMATION - WEED BLADE ATTACHING THE PLASTIC SHIELD AND TRIMMER HEADATTACHING THE METAL SHIELD INSTALLATION OF THE METAL BLADE HOW TO STOP YOUR UNITHOW TO START YOUR UNIT OPERATING POSITION STARTING A WARM ENGINEOPERATING INSTRUCTIONS FOR USE WITH TRIMMER HEAD ADVANCING THE TRIMMER LINEREPLACING THE LINE CARBURETOR ADJUSTMENTSPARK PLUG IGNITION TIMINGNEED SERVICE PART? TROUBLESHOOTING TABLETROUBLE CAUSEOWNER’S WARRANTY RESPONSIBILI YOUR WARRANTY RIGHTS AND OBREPAIR OR REPLACEMENT OF PARTS CONSEQUENTIAL DAMAGES POUowner if the part is under warranty. EMIS