Troy-Bilt TB120BV manual Assembly Instructions Operating Instructions, Extension Cord

ASSEMBLY INSTRUCTIONS

OPERATING INSTRUCTIONS

MOTOR HOUSING	MOTOR	VACUUM
	HOUSING
		BAG
		ADAPTER
VACUUM
BAG
ADAPTER
UPPER	UPPER
VACUUM	VACUUM
TUBE	TUBE

LOWER	VACUUM	LOWER
	BAG
VACUUM		VACUUM
			VACUUM
TUBE		TUBE
			BAG

Fig. 11

Fig. 12

OPERATING INSTRUCTIONS

EXTENSION CORD

MINIMUM WIRE GAUGE RECOMMENDATIONS

5.Use an appropriate extension cord to connect to power. See extension cords.(page 8)

To reduce the risk WARNING: of electric shock,

this unit has a polarized plug (one blade is wider than the other). The outdoor exten- sion cord used with the unit must also be polarized. The plug on the extension cord will fit into the unit only one way. If the plug doesn't fit fully into the unit, reverse the plug. If it does not fit, use a cord with a correct connection. If the cord does not fit into the power supply outlet, contact a qualified electrician to install the proper outlet. DO NOT change the plug on the extension cord or unit in any way.

6.Secure the extension cord to motor housing as shown (Fig. 13)

To avoid serious

WARNING: personal injury, wear goggles or safety glasses at all times when operating this unit. Wear a face mask or dust mask in dusty locations.

OPERATING AS A BLOWER

Hold the blower as shown in Figs. 15 and sweep from side to side with the nozzle several inches above the ground or floor. Slowly advance, keeping the accumulat- ed pile of debris in front of you.

Most dry blowing operations are better suited to low speed than high. Of course, you may choose to use either and you'll probably find the high speed better for moving heavier items like large debris or gravel.

1.Use the blower for trees, shrubs, flower beds and hard-to-clean areas .

2.Use the blower around buildings and for other nor- mal cleaning.

3.Use the blower for walls, overhangs and screens. (Fig. 15)

VOLTS	EXTENSION CORD LENGTH	WIRE SIZE REQUIRED
	25 feet / 7.5 Meters	14 A.W.G.*
120
	50 feet / 15 Meters	14 A.W.G.*
	100 feet / 30 Meters	12 A.W.G.*
*American Wire Gauge

Fig. 13

STARTING AND STOPPING THE BLOWER /VAC

This unit is equipped with an OFF/LOW/HIGH switch . For low speed operation, slide the switch up to the first

TABLE 1

1.When using the appliance, an extension cord of adequate size must be used for safety, and to prevent loss of power and overheating. See Table 1.

2.The extension cord must be specifically designed for outdoor use and marked “SW-A”, “SOW-A”, “STW-A”, “STOW- A”, “SJW-A”, “SJOW-A”, “SJTOW-A”, “SJTW-A”, or “SJTW”.

3.Inspect extension power cord for loose or exposed wires and damaged insulation. If damaged, replace before using appliance.

4.To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized extension cord only one way. If the plug does not fit fully in the extension cord, reverse the plug. If it still does not fit, do not use that extension cord. Do not change the plug in any way.

click (A).

To select high speed, slide the switch up to the second click (B). To turn the unit off, slide the switch all the way down (C). (Fig. 14)

(C) (A) (B)

Fig. 14

Fig. 15

8 9