![](/images/new-backgrounds/1018197/181979x1.webp)
AXIS 8
SETUP AND CONNECTIONS
Typical connection with a mixer is illustrated below.
1.Find a level surface free of excessive vibration to place your equipment
2.Connect the line output connections using the supplied audio cable from the CD Player to the line inputs of your mixer.
3.Connect Fader start cable. Attach your CD play to a similarly equipped DJ mixer with this supplied cable. (This connection can also be used with a remote switch (Page 17))
4.If setting up 2 units, you can connect a relay cable between the units.
(This cable is a standard 1/8” mono – 1/8” mono cable like your fader start cable. It can be purchased from you local music or electronics store or you can use the fader start cable instead for this purpose)
5.Check the voltage selection switch is set to correctly match your local power supply.
6.Connect IEC power cord to the back of the unit then to your power source.
DIGITAL OUTPUTS: This CD player is specially equipped with digital outputs. The format is type 2, form 1, also known as S/PDIF (Sony/Phillips Digital Interface Format).
Check the program functions section of this manual for proper activation
LINE VOLTAGE SELECTION
1)The desired voltage may be set with the VOLTAGE SELECTOR switch on the rear panel of the unit.
2)Do not move the VOLTAGE SELECTOR switch with excessive force as this may cause damage.
3)If the VOLTAGE SELECTOR switch does not move smoothly contact a qualified serviceman.
- The Leader in DJ Technology
©2001 Numark Industries | - 5 - | http://www.numark.com |