If you wish to check the selection before playing back your program, the CHECK button can be pressed to step through each program entry in turn.
If during this check sequence the PLAY button is pressed, the remaining part of your programmed selection will play to the end of the sequence.
Otherwise, to play all the programmed tracks from the beginning of the sequence, press PLAY/PAUSE, or PLAY on the remote control.
The >> button may be pressed to jump to the next track in the programmed sequence, or << button to obtain the previous track in the sequence.
When all programmed tracks have been played, the CD player stops. The same track selection can then be played again by pressing the PLAY/PAUSE button on the front panel, or PLAY on the remote control.
To repeat a programmed sequence continually, press REPEAT whilst playing the program.
To cancel this mode, press PROGRAM.
Note:
The program contents will be cleared if you switch off the power, or open the disc drawer and load another disc. If, however, the same disc is loaded again with the power still switched on, the program sequence is retained in the memory.
SPECIAL FEATURES
DISPLAY
A3.5 CD display brightness can be controlled in three levels by pressing the DISPLAY button on the remote control.
The original setting is maximum brightness, but by pressing the DISPLAY button once, brightness is reduced, and a further press turns the display off.
However, when the display is off, pressing any button returns the brightness to normal (maximum).
Issue 1: March 2005 | A3.5 CD | Instructions for use | Page 14 of 16 |
|
|
|
|