White Outdoor Z - 165 Operation, Before Operating, Operating Guidelines, Stopping the Z-SERIES

Page 12

SECTION 5: OPERATION

BEFORE OPERATING

1.Study this manual carefully. It has been provided to help you safely operate and maintain this unit.

2.Familiarize yourself with all instruments and controls.

3.Fill the fuel tank according to the MAINTENTANCE section.

4.Check the engine oil level as instructed in the separate engine manual.

5.Check the hydraulic oil level as instructed in the MAINTENANCE section.

6.Clean the air filter, if necessary, as instructed in the separate engine manual.

7.Check the rear tires for proper inflation pressure. See tire side wall for proper inflation.

8.Adjust the seat for maximum operator comfort, visibility and control.

9.Remove grass and debris from the engine area.

OPERATING GUIDELINES

Keep all shields in place and keep away from moving parts.

NO RIDERS! Keep children and pets away from unit during operation.

Always look back before operating in reverse.

Don't point the discharge at people.

Avoid slopes. This unit can roll over. Use the SLOPE GAUGE to determine safe operating areas.

Before leaving the seat, disengage the PTO (down), engage the parking brake and turn ignition switch to OFF.

Do not fill gasoline tank when engine is running or while the engine is hot.

STOPPING THE Z-SERIES

1.Bring the tractor to a stop by pulling the drive handles to the neutral position.

2.Disengage the PTO (down).

3.Push down on the brake pedal and hold.

4.Push down on the parking brake pedal to lock engagement. (Refer to Figure 8)

5.Move the throttle lever to the slowest position (toward turtle).

6.Turn the ignition to the OFF position.

7.Remove the key.

WARNING: Always remove the key from the ignition switch to avoid accidental starting.

STARTING THE ENGINE

The Z-series is equipped with a safety interlock-system with the following features:

The engine will not crank or start without the brake pedal fully engaged and the PTO disengaged (down).

If the operator leaves the tractor with the PTO in the RUN position, or the parking brake disengaged, it automatically shuts the engine off.

WARNING: During operation do not run the engine in confined areas such as storage buildings any longer than necessary. Immediately move the tractor outside into open air.

12

Image 12 Contents
Important Read Safety Rules and Instructions Carefully OPERATOR’S ManualCalling Warranty Service Finding Your Model NumberImportant Safe Operation Practices General OperationService Slope OperationDo not ChildrenSafety Labels Found On Unit Slope Gauge IGNITION/LIGHT Switch ControlsLift Handle Throttle Lever and Choke Lever FrontChoke Lever Throttle LeverPower TAKE-OFF PTO Switch Brake PedalParking Brake Pedal Drive Handles Speed Control BARIndicator Panel Seat Adjustment LeverOperation Before OperatingOperating Guidelines Stopping the Z-SERIESStarting a Flooded Engine Driving the Z-SERIESDriving on Slopes Quick Reference Chart Mowing Avoid StreakingPushing Your Unit Adjustments Adjusting the Mower Deck HeightAdjusting the Seat Position Checking the Brake AdjustmentAdjusting Brake Force Steering AdjustmentJam Nuts Lubrication Oil Check Change Capacity TypeGrease Point Locations Maintenance Engine CompartmentFuel Tank Checking Hydraulic OILAdding Hydraulic OIL Draining Hydraulic OILBattery Maintenance Charging the BatteryReplacing the Head Lamp Bulb Changing the FuseRemoving the Battery Installing the BatteryJump Starting the Battery Cleaning the BatteryMower Decks Leveling the Mower DeckWhen either side is lower than Removing the Mower Deck Pin Bracket Installing a NEW Mower Deck Drive Belt Installing the Mower DeckMower Deck Belt Routing Installing a Blade Cutting Blade CareRemoving a Blade Installing a NEW Drive Belt StorageLubrication of Mower Deck Removing the Drive BeltTrouble Shooting Guide Trouble Possible Causes Corrective ActionPage Page Page Page Page MANUFACTURER’S Limited Warranty for