4
Operating
Your Lawn
Tractor
WARNING
Keep hands and feet away from the discharge opening of the cutting deck.
Do not operate the tractor if the interlock system is malfunctioning. This system was designed for your safety and protec- tion.
| 2EVERSE | |
)NDICATOR | 0USH "UTTON | |
,IGHT | 2EVERSE | |
3TOP | ||
0OSITION | ||
0OSITION | ||
| ||
| 3TART | |
| 0OSITION |
Figure
The REVERSE CAUTION MODE position of the key switch module allows the tractor to be operated in reverse with the blades (PTO) engaged.
IMPORTANT: Mowing in reverse is not recommended.
To use the REVERSE CAUTION MODE:
IMPORTANT: The operator MUST be seated in the tractor seat.
1.Start the engine as previously instructed on page 17 in this Operator’s Manual.
2.Turn the key from the NORMAL MOWING (Green) position to the REVERSE CAUTION MODE (Yellow) position of the key switch module. See Figure
3.Depress the REVERSE PUSH BUTTON (Orange, Triangular Button) at the top, right corner of the key switch module. The red indicator light at the top, left corner of the key switch module will be ON while activated. See Figure
4.Once activated (indicator light ON), the tractor can be driven in reverse with the cutting blades (PTO) engaged.
5.Always look down and behind before and while backing to make sure no children are around.
6.After resuming forward motion, return the key to the NORMAL MOWING position.
IMPORTANT: The REVERSE CAUTION MODE will remain activated until:
a.The key is placed in either the NORMAL MOW- ING position or STOP position.
b.The operator leaves the seat (Models with Electric PTO ONLY).
c.The operator engages the parking brake by fully depressing the brake pedal and holding it down while gently pushing the parking brake button inward (Models with Manual PTO ONLY).
WARNING
AVOID SERIOUS INJURY OR DEATH
•GO UP AND DOWN SLOPES, NOT ACROSS.
•AVOID SUDDEN TURNS.
•DO NOT OPERATE THE UNIT WHERE IT COULD SLIP OR TIP.
•IF MACHINE STOPS GOING UPHILL, STOP BLADE(S) AND BACK DOWNHILL SLOWLY.
•DO NOT MOW WHEN CHILDREN OR OTHERS ARE AROUND.
•NEVER CARRY CHILDREN, EVEN WITH BLADES OFF.
•LOOK DOWN AND BEHIND BEFORE AND WHILE BACKING.
•KEEP SAFETY DEVICES (GUARDS, SHIELDS, AND SWITCHES) IN PLACE AND WORKING.
•REMOVE OBJECTS THAT COULD BE THROWN BY THE BLADE(S).
•KNOW LOCATION AND FUNCTION OF ALL CONTROLS.
•BE SURE BLADE(S) AND ENGINE ARE STOPPED BEFORE PLACING HANDS OR FEET NEAR BLADE(S).
•BEFORE LEAVING OPERATOR’S POSITION, DISENGAGE BLADE(S), PLACE THE SHIFT LEVER IN NEUTRAL, ENGAGE BRAKE LOCK, SHUT ENGINE OFF AND REMOVE KEY.
READ OPERATOR’S MANUAL
Engaging the Parking Brake
To engage the parking brake:
1.Fully depress the brake pedal and hold it down with your foot while gently pushing the parking brake button inward.
2.Hold the parking brake button in while removing your foot from the brake pedal.
3.Once engaged, the parking brake button and the brake pedal will lock in the “down” position.
To disengage the parking brake:
1. Slightly depress the brake pedal.
NOTE: The parking brake must be engaged if the operator leaves the seat with the engine running or the engine will automatically shut off.
Setting the Cutting Height
1.Select the height position of the cutting deck by placing the deck lift lever in any of the six different cutting height notches on the right side of the fender.
2.Adjust the deck wheels so that they are between
16