White LC-436 manual Operation, Gas And Oil Fill-Up, Starting Engine, Stopping Engine

Page 10

SECTION 8: OPERATION

Gas And Oil Fill-Up

Oil:

•Only use high quality detergent oil rated with API service classification SF, SG or SH. Use SAE30 oil; do not use 10W40 oil.

•Fill oil sump and check the oil level following steps below.

a.Position the mower on level ground and clean area around oil fill plug.

b.Remove oil fill plug and dipstick. Wipe dipstick clean, insert it into oil fill hole and tighten securely.

c.Remove dipstick and check oil level. If the oil is not upto FULL mark on the dipstick, pour recommended oil through the oil fill and check the level again. Install oil fill plug and dipstick, tighten securely.

NOTE: Although multi-viscosity oils (5W30, 10W30, etc.) improve starting in cold weather, these multiviscosity oils will result in increased oil consumption when used above 32oF. Check the oil level more frequently to avoid possible engine damage from running low on oil.

Gasoline

WARNING: Never fill fuel tank indoors, or when engine is running or hot. Do not smoke when filling up the fuel tank.

•Clean area around fuel cap. Remove cap. Use a funnel to prevent spillage.

•Pour approximately 1.5 quarts of fresh, regular grade, unleaded gasoline slowly to the fuel tank.

IMPORTANT: Never mix engine oil with gasoline.

•Fill tank to 1/2” below the bottom of the filler neck. Wipe any fuel spillage. Do not fill fuel tank completely. Provide space for fuel expansion.

Starting Engine

WARNING: Be sure no one other than the operator is standing near the lawn mower while starting engine or operating mower.

Never run engine indoors or in enclosed, poorly ventilated areas. Engine exhaust contains carbon monoxide, an odorless and deadly gas.

Keep hands, feet, hair and loose clothing away from any moving parts on engine and lawn mower.

•To prevent the unit from sliding, place your foot firmly against the tire.

•Attach spark plug wire to spark plug. Make certain the metal cap on the end of the spark plug wire is fastened securely over the metal tip on the spark plug.

•Move throttle control to FAST (rabbit) position.

•Push primer three times. Wait about two seconds between each push. In cold weather around 55o F or below, prime five times. Do not prime to restart a warm engine after a short shutdown.

•Grasp starter handle and pull rope out slowly until engine reaches the start of compression cycle (rope will pull slightly harder at this point). Let the rope rewind slowly. Pull rope with a rapid, continuous, full arm stroke. Keeping a firm grip on the starter handle, let the rope return to the starter slowly.

Stopping Engine

•Release blade control handle to stop the engine and the blade.

•Disconnect spark plug wire and move away from spark plug to prevent accidental starting. Do not use the throttle control to stop the engine.

Using Your Lawn Mower

Your mower is designed to operate as a rear bagger, mulching or a side-discharge unit.

•To convert from a mulcher to a side-discharge or a rear bagger unit, refer to instructions on page 8. Do not operate the mower without the mulching cover or the discharge chute properly installed and tightly secured.

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents OPERATOR’S Manual Table of Contents Important Safe Operation Practices General OperationYour Responsibility Do notSlope Gauge Your footing and you could slip, resulting inseriousinjuryUnpacking Setting UP MowerDisconnecting Spark Plug Removing Unit From CartonAssembling Handle Attaching Starter RopeAttaching Side-Discharge Chute Attaching Rear BaggerPrimer ‘CONTROLSRecoil Starter Blade Control HandleStarting Engine OperationGas And Oil Fill-Up Stopping EngineLubrication MaintenanceHeight Adjustment WheelsEngine Maintenance Service & AdjustmentsCleaning Mower Blade CareTo Replace Blade Adjusting Handle HeightTo Sharpen Blade Adjusting Cutting Height Engine OFF-SEASON StorageMower OtherTROUBLE-SHOOTING Guide Problem Possible Cause Corrective ActionRepair Parts Code Description MANUFACTURER’S Limited Warranty for

LC-436 specifications

The White LC-436 is a modern, versatile vehicle that stands out in the crowded automotive market, combining functionality and aesthetic appeal. Designed with an emphasis on efficiency and performance, it meets the demands of both city driving and rugged terrains, making it an ideal choice for a variety of users, from families to adventurous individuals.

One of the standout features of the White LC-436 is its powerful engine options. Equipped with a range of turbocharged engines, the vehicle offers excellent fuel efficiency without compromising on power. The engine lineup includes both petrol and diesel variants, catering to diverse consumer preferences. The advanced engineering behind the engines ensures that the LC-436 delivers smooth acceleration and consistent performance, whether in stop-and-go traffic or on open highways.

The design of the White LC-436 emphasizes aerodynamics, which not only contributes to its striking exterior but also enhances its overall efficiency. The sleek contours and bold front grille create a commanding presence on the road, while the spacious interior is crafted with comfort in mind. High-quality materials are used throughout the cabin, providing an inviting atmosphere for both the driver and passengers.

In terms of technology, the LC-436 is packed with innovative features that enhance the driving experience. The infotainment system includes a touchscreen interface that supports smartphone integration, allowing for easy access to navigation, music, and communication apps. Additionally, advanced driver-assistance systems such as adaptive cruise control, lane-keeping assist, and collision avoidance technology are integrated to ensure safety and ease of use.

The handling capabilities of the White LC-436 are also noteworthy. With a sophisticated suspension system and responsive steering, the vehicle offers a smooth ride across various terrains. All-wheel drive options further enhance its off-road capabilities, making it suitable for outdoor adventures.

Manufactured with sustainability in mind, the White LC-436 incorporates eco-friendly technologies, such as energy-efficient lighting and reduced emissions. This commitment to the environment is increasingly important to today's consumers.

In summary, the White LC-436 combines advanced engineering, modern design, and cutting-edge technology, establishing itself as a versatile and reliable vehicle. Whether navigating city streets or exploring off the beaten path, the LC-436 is well-equipped to meet the needs of drivers in today's dynamic world.
Top Page Image Contents