MOUNTING AND WIRING INSTRUCTIONS
CAUTION: For fixtures labeled for outdoor and wet location use, provide a
NOTE: Underwriters Laboratories (UL) does not require all fixtures to have ground wires. These fixtures meet all UL specifications.
1.Turn off power at circuit box to avoid possible electric shock.
2.Remove cap nuts 1 (A) from back plate (B) and remove universal mounting plate or cross bar (C) leaving mounting screws (D) in place.
3.Secure universal mounting plate or cross bar (C) to outlet box (E) (vertically or horizontally, see fig. 1) with outlet box screws (F) (not included).
4.Identify color coding of fixture wires (see figure 2 on page 11).
5.To connect wires, take black fixture wire (group A from fig. 2) and place evenly against black outlet box wire. Do not twist wires.
6.Fit wire connector (G) (see fig. 1) over wires and twist until there is a firm connection. If wire connector (G) easily comes off, reattach and check again for a firm connection.
7.Repeat steps 5 and 6 with the white (group B from fig. 2) fixture and outlet box wires.
8.Partially thread green grounding screw (H) into side hole (I) on mounting plate or cross bar (C) (see fig. 1).
9.Wrap ground wire from fixture around green grounding screw (H) leaving enough excess wire to then connect ground wire and outlet box wire with wire connector (G), if applicable.
10.Tighten green grounding screw (H). Do not over tighten.
11.Tuckwires inside outlet box (E) (see fig. 1).
FIXTURE ASSEMBLY INSTRUCTIONS
1.Place back plate (B) over mounting screws (D) (see fig. 1).
2.Secure into place with cap nuts 1 (A).
3.Install lamp(s). Do not exceed recommended wattage.
4.Slide glass panels (J) into place inside cage (K).
5.Remove cap nuts 2 (L) from top of cage (K).
6.Raise cage (K) while lining up holes in cover (M).
7.Secure with cap nuts 2 (L).
8.Screw finials (N) to top and/or bottom (if applicable).
4