Problems ?, Possible Cause, Remedy | Musical Fidelity A308 CR

PROBLEMS ?

Basic problem solving with a pre-amplifier is similar to troubleshooting any other electrical or electronic equipment. Always check the most obvious possible causes first. To give you a few ideas of what to look for, check the following:

Problem	Possible Cause	Remedy
No power when MAINS	Mains plug not inserted	Plug in securely
POWER switch is operated	fully into the rear socket
No sound	Tape monitor function has	Cancel tape monitor
	been selected (see page 7)	function by pressing the
		MONITOR button again
	Mute function is selected	Press mute button on the
		remote control
	Wrong connections between	Check audio lead inter-
	the A308 CR Pre and ampli-	connections between the
	fier	pre-amplifier and amplifier
Remote control unit does	POWER switch is set to OFF	Press POWER button
not operate
	Batteries not inserted in remote	Insert batteries
	control unit
	Batteries are flat	Replace batteries - do not
		mix old and new ones
Range of remote control has	Batteries are running out	Replace batteries - do not
greatly reduced		mix old and new ones

If none of these actions effect a cure, please contact your dealer, or an authorised Musical Fidelity service agent. Remember, never open the case of the A308 CR pre-amplifier yourself, as this will invalidate the guarantee.

Issue 3: July 2002	CR Pre	Instructions for Use Page 8 of 9
A308