Operating Tips
IMPORTANT
■Before closing down the cup (reducing rates), the operator should make certain that the cups are not full of seed. If cups are full of seed (especially small, round, hard seed), it may be necessary to cover the meter holes and run seeder a short dis- tance to reduce level of seeds in meter. Failure to do so could result in damage to seed cup.
1.Do not allow dirt to build up on the roller sprockets. Clean sprockets and chain as needed. Excessive buildup of material can cause damage to the roller and idler shafts.
2.Always run the drive chain with some slack in the chain. An extremely tight chain can damage the roller shaft, the roller bearings, and the idler shaft and bearing.
3.When properly torqued, the hex lock nut (1) drives the seedbox roller chain. Disengage the seedbox chain, when not in use, by backing off a 1/4 turn on the lock nut.
1 1
DP8DP8
Figure 9. Drive Chains
Pre-Operation Check List
(OWNER’S RESPONSIBILITY)
___ Review and follow all safety rules and safety decal instructions on page 5 through page 8.
___ Check that equipment is properly and securely attached to tractor.
___ Check that all safety decals are installed and in good condition. Replace if damaged.
___ Do not allow riders.
___ Check that all hardware is properly installed and secured.
___ Check that shields and guards are properly installed and in good condition. Replace if dam- aged.
___ Check all lubrication points and grease as instructed in Lubrication Information, page 12.
___ Make sure tractor ROPS or ROPS cab and seat belt are in good condition. Keep seat belt securely fastened during operation.
12 Operation | MAN0101 (Rev. 9/15/2006) |
|
|