VACUUM INSTALLATION
REMOVE DISCHARGE CHUTE
1. | Remove mower deck discharge chute and hinge |
| by removing two carriage bolts (2) and nuts (3) and |
| lifting the chute (1) away from the deck. |
2. | Place the discharge chute and hinge on the chute |
| adapter (4) and secure with carriage bolts (2) and |
| nuts (3) previously removed. |
| NOTE: The discharge chute must be installed |
1.Attach hose adapter (2) to vacuum housing (1) using six whiz bolts (3) and whiz nuts (4).
NOTE: To prevent grass buildup inside the adapter, install bolts with nuts (4) on the outside as shown in Figure 2.
INSTALL VACUUM HOUSING
whenever the vacuum housing assembly is |
removed. |
3. Install discharge chute and adapter to deck using |
pivot mount, clevis shaft bracket, and lynch pin as |
described in ‘Attach Discharge Chute” on page 8. |
| 34 |
| 34 |
61 |
|
|
|
|
| 61 |
|
|
|
| 59 |
|
| 60 |
|
60 |
| 62 | |
34. | 73163 | 5/16 NC Whiz nut |
|
59. | 75208 | Discharge chute adapter |
|
60. | 78182 | 5/16 NC x 1 Carriage bolt |
|
61. | 78107 | Discharge chute |
|
62. | 33000 | Lynch pin |
|
A
37
37
1
34
62
38
33
35
36
Figure 1. Discharge Removal
ATTACH HOSE ADAPTER
1. |
| Vacuum fan housing |
2. | 70570 | Hose adapter |
3. | 70067 | 1/4 NC x 1/2 Whiz bolt |
4. | 70065 | 1/4 NC Whiz nut |
| 3 |
|
2 |
|
|
4 |
|
|
| 1 |
|
|
|
Figure 2. Hose Adapter Installation
1.Vacuum housing assembly
33.71851 5/16 NC x 3/4 Hex whiz bolt
34.73163 5/16 NC Whiz nut
35.Vacuum mount (54" or 61" deck)
36.71637 3/8 NC x 1 Hex whiz bolt
37.70069 3/8 NC Whiz nut
38.75109 Vacuum front mount
62.33000 Lynch pin
Figure 3. Vacuum Housing Installation
1.Install vacuum mount bracket (35) using three whiz bolts (36) and whiz nuts (37).
2.Install vacuum front mount (38) using whiz bolts (33) and whiz nuts (34).
3.Insert the pivot shaft (A) on the vacuum housing assembly (1) into sleeve of vacuum mount (35).
MAN0258 (Rev. 12/14/2007) | Installation 7 |
|
|