Woods Equipment L59, L36 manual Transportation, Maintenance, Storage

SAFETY RULES

ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!

„Do not stop, start, or change directions sud- denly on slopes.

„Use extreme care and reduce ground speed on slopes and rough terrain.

„Watch for hidden hazards on the terrain during operation.

„Stop power unit and equipment immediately upon striking an obstruction. Turn off engine, remove key, inspect, and repair any damage before resuming operation.

TRANSPORTATION

„Always comply with all state and local lighting and marking requirements.

„Never allow riders on power unit or attachment.

„Do not operate PTO during transport.

„Watch for hidden hazards on the terrain.

„Do not operate or transport on steep slopes.

„Do not operate auxiliary hydraulics during transport.

„Do not operate or transport equipment while under the influence of alcohol or drugs.

MAINTENANCE

„Before dismounting power unit or performing any service or maintenance, follow these steps: disengage power to equipment, lower the 3-point hitch and all raised components to the ground, operate valve levers to release any hydraulic pres- sure, set parking brake, stop engine, remove key, and unfasten seat belt.

„Do not modify or alter or permit anyone else to modify or alter the equipment or any of its compo- nents in any way.

„Always wear relatively tight and belted clothing to avoid getting caught in moving parts. Wear sturdy, rough-soled work shoes and protective equipment for eyes, hair, hands, hearing, and head; and respirator or filter mask where appropriate.

„Never go underneath equipment (lowered to the ground or raised) unless it is properly blocked and secured. Never place any part of the body under-

neath equipment or between moveable parts even when the engine has been turned off. Hydraulic system leak down, hydraulic system failures, mechanical failures, or movement of control levers can cause equipment to drop or rotate unexpect- edly and cause severe injury or death. Follow Oper- ator's Manual instructions for working underneath and blocking requirements or have work done by a qualified dealer.

„Make sure attachment is properly secured, adjusted, and in good operating condition.

„Keep all persons away from operator control area while performing adjustments, service, or maintenance.

„Make certain all movement of equipment com- ponents has stopped before approaching for ser- vice.

„Frequently check blades. They should be sharp, free of nicks and cracks, and securely fastened.

„Do not handle blades with bare hands. Careless or improper handling may result in serious injury.

„Your dealer can supply genuine replacement blades. Substitute blades may not meet original equipment specifications and may be dangerous.

„Tighten all bolts, nuts, and screws to torque chart specifications. Check that all cotter pins are installed securely to ensure equipment is in a safe condition before putting unit into service.

„Make sure all safety decals are installed. Replace if damaged. (See Safety Decals section for location.)

„Make sure shields and guards are properly installed and in good condition. Replace if damaged.

„Wear gloves when installing belt. Be careful to prevent fingers from being caught between belt and pulley.

STORAGE

„Block equipment securely for storage.

„Keep children and bystanders away from stor- age area.

™

L59Safety Rules (Rev. 9/1/2006)

Safety 5