SERVICE & ADJUSTMENTS
Parking Brakes
9The Swisher ZT2460 is equipped with an Automatic Parking Brake system on each control handle.
9When the control handles are in the out most position the parking brakes are on.
9Adjustment for the system is located on the ends of the brake cable at the hydro pan & frame
9Raise the rear wheel off the ground.
9Disengage the hydro to be adjusted with the hydro release handle at the rear of the unit
9Adjust so that the brake is not on when the handles are in the operator position. The wheel should turn freely.
9The wheel should not turn when the handle is move to the engaged or outward position.
9To tighten the brake, turn the adjustment nuts towards the end of the cable.
9Recheck adjustment with control handle
9Lower unit back to the ground
9Reengage the hydro at the rear of the unit
WARNING
When it is necessary to raise the mower for any repair or service, use jackstands to provide adequate support. DO NOT rely on hydraulic or mechanical jacks
25