Wright Manufacturing 26980 owner manual Battery Service, Cleaning the Mower

Page 15

50.Lift the mower so that the rear wheels are off the ground. Be careful to support the mower so that it will not fall or tip while the system is

bled of air. With the bypass valves open and the engine running, slowly move the control levers back and forth five or six times. Now close the bypass valves and with the engine running, slowly move the control levers back and forth five or six times. It may be necessary to repeat the above steps until all the air is purged and the rear wheels are turning at normal speed. After purging is complete, adjust the oil level in the reservoir if necessary.

Battery Service

The battery is 12 volts and is a maintenance free battery. Charge the battery only if it will not start the mower properly. Remove the battery from the mower before charging. Follow the instructions of the battery charger for proper and safe charging of the battery.

Cleaning the Mower

The underside of the mower deck should be checked and cleaned twice daily, and more often if the grass being mowed is lush or wet. The entire mower should be cleaned daily at the end of the work day.

Cleaning should be done with a leaf blower or low- pressure compressed air. Wash with water only when necessary and do not use a pressure washer or nozzle as the water can enter electrical connections causing an electrical short, rust and corrosion. When washing with water, do so when the unit has cooled down. Washing a hot machine can cause various unseen system damage. If water is used for cleaning, immediately dry it with a leaf blower or low-pressure compressed air. Once the wash is complete, always lubricate and grease all applicable areas.

12

Image 15
Contents WARNING READ THIS MANUAL BEFORE USING SAFETY ALERT avoided, could result in death or serious injuryavoided, may result in minor or moderate injury Pre-DeliveryService of Mower by Dealer TABLE OF CONTENTSMaintenance Interval Chart Maintenance RecordPre-DeliveryService of Mower by Dealer Page Owner/User Notice GENERAL SAFETY INSTRUCTIONSPLEASE BE CAREFUL INTRODUCTIONInspection of Mower Before Each Use Scheduled Mower Maintenance SafetyInitial Operating Safety Guidelines User ClothingOperation on Slopes Replacement PartsOperation in Forward Direction Fuel SafetyOperation During Zero-RadiusTurns Operation in ReverseFAILURE TO FOLLOW SAFE OPERATING Hydraulic SafetyREMEMBER - YOUR MOWER CAN BE ONLY AS SAFE AS THE OPERATORHow to drive the mower OPERATING INSTRUCTIONSInspection of Mower Do not use the mower How to start the mowerNever drive straight onto or off a curb How to Drive the Mower Over a CurbHow to Use the Mower on Varying Terrain How to Adjust NeutralHow to Change the Speed/Sensitivity Adjustment How to Perform the Tracking AdjustmentHow to Test/Use the Blade Clutch/Brake Switch How to Move the Mower if the Engine Won’t Start Tire Maintenance and PressureDeck Adjustments Belt Tension AdjustmentCleaning the Mower Battery ServiceMaintenance Interval Chart MAINTENANCE ITEMNOTES Unit Hours Maintenance RecordMaintenance/Service Performed DateThis Page Intentionally Left Blank Wright Manufacturing, Inc 4600-XWedgewood Blvd Frederick, MDExclusions 4600X Wedgewood Blvd Frederick, MD