Yazoo/Kees RBSIC050, RBSIT550, RBSIT551, SBSIC050, RHON050 Service, Clutch Control Cable

Page 8

SERVICE

Figure 12

2.Lubricate SATELLITE SHAFTS on DETHATCHER with

CLUTCH CONTROL CABLE

Lubricate CABLE with oil, graphite or a penetrating- type spray lubricant as required.

BELT/CLUTCHADJUSTMENT

Position of Bail when CLUTCH engages, is adjusted by loosening jam nuts on threaded barrel end of CLUTCH CONTROL CABLE, turning jam nuts to desired position, then tightening in new position. See Figure 13.

CAUTION:

NEVER ADJUST MACHINE WITH

ENGINE RUNNING

Figure 13

OFF SEASON STORAGE

Thoroughly clean all external surfaces, Shaft Assembly (including Fingers or Slicers) and underside of unit before storing the unit. Grease all fittings and lubricate all wear surfaces with oil.

1.Drain gasoline from fuel system and drain the crankcase oil (Refer to Engine Manual for details).

2.At the start of the new season, replenish engine crankcase oil and add gasoline to the fuel tank.

3.Before starting, move the ENGINE CONTROL to “STOP” and pull Rope Starter slowly several times. If excessive resistance is felt, remove the spark plug and pull Rope Starter rapidly to spin the engine and clear oil from the cylinder. Clean and reinstall the spark plug before attempting to start the engine.

8

Image 8
Contents Safety and Operators Manual for Important Safety Instructions Familiarization NomenclatureOperating Instructions Before OperatingPRE-START Check List STARTING-STOPPINGTransporting to Site Handle BAR AdjustmentDethatchingprocedure Dethatcher Depth Adjustment SlicingprocedureSlicer Depth Adjustment ClutchcontrolService Parts & Assistance DETHATCHER/SLICER LubricationWheels DETHATCHER/SLICER Moving Parts ALL MachinesService BELT/CLUTCHADJUSTMENTClutch Control Cable OFF Season StoragePage