Zenoah BK4310FL, BK3410FL owner manual SE7 SE8 SE9, Adjusting Throttle Cable, Attaching the Handle

SE7

SE8

SE9

4. SET UP

■ADJUSTING THROTTLE CABLE

•Proper play of the throttle cable is 1–2mm. Place the throttle lever to the lowest speed position (i.e. fully released status). Pull the throttle cable lightly with fingers to check its play. Readjust the position of cable adjuster if the play is too large or too small. To readjust, slacken a lock nut. Turn the cable adjuster clockwise to increase the play, or counterclockwise to decrease the play. Lock the cable adjuster with the lock nut after readjustment. (SE7)

(1)Cable adjuster

(2)Lock nut

(3)Throttle cable

■ATTACHING THE HANDLE

•Attach the loop handle as shown in the accompanying diagram. Note that it is recommended that you attach the handle so that the handle is located some 30–40cm away from the front end of the right-hand grip. (SE8)

(1)Loop handle

(2)Screw

(3)Washer

(4)Nut

■ATTACHING THE DEBRIS GUARD

WARNING

Never use the machine without the debris guard.

•Attach the guard to the clamp on the outer pipe just touching the gearcase. Fix it with 2 bolts. (SE9)

(1)Bolt (M5x25)

(2)Clamp

(3)Debris guard

(4)Place to be attached for blade use

(5)Place to be attached for line head

11