Engine
Pulley
Clutching
Idler
Stationary
Idler
Center
Span
Keeper
Transaxle
Pulley
TO ADJUST STEERING WHEEL ALIGN- MENT
If steering wheel crossbars are not
horizontal (left to right) when wheels are positioned straight forward, remove steer- ing wheel and reassemble with crossbars horizontal. Tighten securely.
FRONT WHEEL TOE-IN/CAMBER
The front wheel
TO REMOVE WHEEL FOR REPAIRS
1.Block up axle securely.
2.Remove axle cover, retaining ring and washers to allow wheel removal (rear wheels have a square key - Do not lose).
3.Repair tire and reassemble.
NOTE: On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.
4.Replace washers and snap retaining ring securely in axle groove.
5.Replace axle cover.
NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.
Washers
Retaining
Ring
Axle
Cover
Square Key
(Rear Wheel Only)
TO START ENGINE WITH A WEAK BATTERY
WARNING:
If your battery is too weak to start the engine, it should be recharged. (See "BAT- TERY" in the MAINTENANCE section of this manual).
If “jumper cables” are used for emergency starting, follow this procedure: IMPORTANT: Your tractor is equipped with a 12 volt system. The other vehicle must also be a 12 volt system. Do not use your tractor battery to start other vehicles.
TO ATTACH JUMPER CABLES -
1.Connect one end of the RED cable to the POSITIVE (+) terminal of each
2.Connect one end of the BLACK cable to the NEGATIVE
3.Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER -
1.BLACK cable first from chassis and then from the fully charged battery.
2.RED cable last from both batteries.
Weak or Dead | Fully Charged |
Battery | Battery |
24
