Zenoah BK3410FL, BK4310FL SE10 SE11, Blade, Use ZENOAH genuine cutting blade for exchange, Set Up

SE10

SE11

4. SET UP

■BLADE

WARNING

•Never attach nor remove a cutting blade while the engine is running.

•Use ZENOAH genuine cutting blade for exchange.

•Wear sturdy gloves for attaching/removing a metallic cutting blade to avoid injury.

1.Loosen the nut, remove holder A and holder B from the gear case. (SE10)

(Note that this is a left-turning screw.)

(1)Bar

(2)Holder B

(3)Holder A

2.Attach the cover (SE11,(11)) and fix it with screw.

3.Insert blade between cutter holder A and cutter holder B. (SE11)

4.Attach cover and spring washer. (SE11)

5.Screw the bolt to fix them into place. (SE11)

Tightening torque:

14.7~19.6 N-m/150~200kgf-m

■LINE HEAD (SE11)

1.Detach bolt (1), spring washer (2), washer(3), bolt cover (4) and cover (11).

2.Put holder B (5) to holder A (9). Screw arbor bolt (12) in holder B (5).

3.Then attach the cutting head to the gear shaft over the holders. Hard-tighten it securely.

(1)Bolt

(2)Spring Washer

(3)Washer

(4)Bolt cover

(5)Holder B

(6)Blade

(7)Gear shaft

(8)Bar

(9)Holder A

(10)Gear case

(11)Cover preventing grass from getting caught up

(12)Arbor bolt

12