Yard-Man 454 manual Operating Your Tiller, Before Starting, To Start Engine, To Stop Engine

Page 9

SECTION 5: OPERATING YOUR TILLER

NOTE: Engine is shipped without oil.

WARNING: Use the reverse tine drive when tilling virgin ground, sod or hard soil. Use the forward tine drive when cultivating or tilling soft ground.

Before Starting

•Service engine with oil as instructed in the separate engine manual packed with your unit.

•Fill fuel tank with clean, fresh, lead-free, low-lead or regular grade leaded gasoline.

To Start Engine

WARNING: Be sure no one is standing in front of the tiller while the engine is running or being started.

•Place the throttle control lever in the FAST (rabbit) position.

•Move choke lever to CHOKE position.

NOTE: A warm engine may not require choking.

•Stand at side of tiller. Grasp the starter handle with your right hand and pull out slowly, until it pulls slightly harder. Place your left hand on the lower portion of the upper handle.

•Pull starter handle rapidly. Do not allow handle to snap back. Allow it to rewind slowly while keeping a firm hold on the starter handle.

•Repeat steps 3 and 4 until engine starts.

•As engine warms up and begins to operate evenly, move choke lever gradually to RUN position. If engine falters, return to choke position, then slowly move to RUN position.

•Refer to engine manual for additional engine information.

NOTE: After starting engine and prior to using the tiller, be certain to check the clutch adjustment as described in “Checking the Clutch Adjustment” section of Assembly Instructions.

To Stop Engine

•Move throttle control to the STOP position.

•Disconnect spark plug wire and ground to prevent accidentally starting while equipment is unattended.

NOTE: After the first ten hours of operation, recheck the clutch adjustment. Refer to “Checking the Clutch Adjustment” section of the Assembly Instructions.

WARNING: When operating the tiller for the first time, use the depth stake setting that gives 1 inch of tilling depth (second hole

from the top). See Figure 7.

Tilling depth is controlled by the depth stake which can be adjusted to five different settings. See Figure 7. Adjust the side shields as shown in Figure 8, as you adjust the depth stake. Be certain spark plug wire is disconnected and grounded against the engine.

•When using the tiller for the first time, use the second adjustment hole from the top (1" of tilling depth). See Figure 7.

•When breaking up sod and for shallow cultivation, use the setting which gives 1" of tilling depth (second hole from the top). Place the side shields in their lowest position. For further depth, raise the depth stake and side shields and make one or two more passes over the area.

•When tilling loose soil, depth stake may be raised to its highest position (use bottom adjustment hole) to give the deepest tilling depth. Raise the side shields to their highest position.

 

Transport

Use This

Position

 

Position

 

First Time

 

 

Clevis

 

Pin

 

Hairpin

 

Clip

Figure 7

•To transport tiller, lower the depth stake (use top adjustment hole).

•To adjust the depth stake, remove the clevis pin and hairpin clip. See Figure 7. Move the depth stake to the desired setting.

•To adjust the side shields, remove the front wing nut and loosen the rear wing nut. See Figure 8.

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Operator’s Manual Table of Contents Training Important Safe Operation PracticesMaintenance And Storage Loose Parts Handle Assembly Depth ControlStake RodAssemblyAttaching The Handle Assembly Attaching Depth Stake AssemblyAssembling Your Tiller UnpackingAttaching The Clutch Cable Checking The Clutch AdjustmentAttaching The Control Rod Control RodClutch Tire PressureBefore Starting Operating Your TillerTo Start Engine To Stop EngineBelt Tension Adjustment Handle AdjustmentCarburetor Adjustment To Operate The TillerCleaning The Tine Area ServiceBelt Replacement Maintaining Your TillerTires Torx Screws Belt Cover Hex Cap Nut Flat Washer Self TapIdler Pulley Rod Engine Belt Keeper Brkt Trouble Trouble Shooting GuidePossible Causes Corrective ActionParts List for Model Model Model Labels Model Description MANUFACTURER’S Limited Warranty for

454 specifications

The Yard-Man 454 is a standout machine in the realm of outdoor power equipment, designed specifically for the discerning homeowner or landscaper seeking efficiency and power in their lawn care routine. With its robust construction, advanced features, and user-friendly design, the Yard-Man 454 excels in providing a well-manicured lawn with minimal effort.

At the heart of this lawn mower is a powerful 4-cycle engine that delivers impressive torque and performance. It features a 454cc engine, which ensures ample power for tackling even the toughest grass and uneven terrains. The engine is both fuel-efficient and environmentally friendly, providing users with the power they need without excessive fuel consumption or harmful emissions.

One of the standout characteristics of the Yard-Man 454 is its cutting deck. Designed with a 21-inch steel deck, it offers a perfect balance of maneuverability and durability. This size allows for easy navigation around flower beds and obstructions while still providing a substantial cutting area. The adjustable cutting height feature is another significant advantage, offering multiple settings that allow users to customize the lawn cut according to their preferences and seasonal needs.

The mower also encompasses advanced mulching technology, providing an eco-friendly solution to lawn care. It finely chops grass clippings and redistributes them back into the lawn, enriching the soil and promoting healthy grass growth. Furthermore, the discharge feature offers flexibility, allowing users to choose between side discharge or bagging options for convenience.

Ergonomics and ease of use are also integral to the Yard-Man 454’s design. It is equipped with an adjustable handle that provides comfort during extended use, and its lightweight design ensures easy maneuverability. The mower’s compact size allows for effortless storage, making it an ideal choice for homeowners with limited space.

In terms of maintenance, the Yard-Man 454 is designed to simplify the process. The easy-access oil and air filter locations help users perform routine checks and changes without hassle. Additionally, the mower comes with durable wheels that provide excellent traction and stability, even on uneven surfaces.

In summary, the Yard-Man 454 combines power, versatility, and user-friendly features, making it an excellent addition to any lawn care toolkit. With its strong engine, flexible cutting options, and thoughtful design, it ensures that beautiful lawns can be achieved without the burden of complicated technology or strenuous effort.
Top Page Image Contents