Yazoo/Kees ZPKW5426 manual General Maintenance

Page 14

SAFETY

General Maintenance

Never operate machine in a closed area.

Keep all nuts and bolts tight to be sure the equipment is in safe working condition.

Never tamper with safety devices. Check their proper operation regularly.

Keep machine free of grass, leaves, or other debris buildup. Clean oil or fuel spillage and remove any fuel-soaked debris. Allow machine to cool before storing.

If the machine strikes a foreign object, stop and inspect the machine. Repair, if necessary, before restarting.

Never make any adjustments or repairs with the engine running.

Check grass catcher components and the discharge guard frequently and replace with manufacturer’s recommended parts, when necessary.

Mower blades are sharp. Wrap the blade or wear gloves, and use extra caution when servicing them.

Check brake operation frequently. Adjust and service as required.

Maintain or replace safety and instruction labels, as necessary.

Do not modify safety equipment. Check regularly to be sure it works properly. The machine must not be driven with defective or unmounted protective plates, protective cowlings, safety switches, or other protective devices.

Do not change the settings of governors and avoid running the engine with overly high engine speeds. If the engine runs too fast, there is risk for damaging the machine components.

Be very careful when handling battery acid. Acid on skin can cause serious corrosive burns. If battery acid is spilled on skin, rinse immediately with water.

Acid in the eyes can cause blindness, contact a doctor immediately.

Be careful when servicing the battery. Explosive gases form in the battery. Never perform maintenance on the battery when smoking or near open flames or sparks.

The battery can explode and cause serious injury or damage.

Ensure that the equipment is in good condition and that all nuts and bolts, especially those fastening the blade attachments, are properly tightened and torqued

8011-515

Never drive the machine in an enclosed space

WARNING!

Use protective glasses for maintenance work.

WARNING!

The battery contains lead and lead compounds, chemicals that are considered to cause cancer, birth defects, and other reproductive system damage. Wash your hands after handling the battery.

14

Image 14
Contents Operator Manual Page Contents Page Introduction Good Service Manufacturing NumberSymbols and decals Manual Performing any General Operation SafetySafety Instructions Never take passengers Personal Safety Equipment Slope OperationChildren Safe Handling of Gasoline General Maintenance Risk of sparking Transport Rollover Protection System Rops Spark ArrestorsControls Control LocationsMotion Control Levers Hour Meter TrackingParking Brake Blade SwitchIgnition Switch Ignition switch RUN position Cutting Height Pedals FusesChoke Control Seat Adjustment Lever Fuel Shut Off ValveRefueling Steering OperationTraining Roll Bar and Safety Belt Before StartingStarting the Engine Set the throttle Turn to Start position Push choke in after starting To remove cables, reverse order Weak BatteryJumper Cables Running Ensure that no one is near mower when engaging blade switch Operating on HillsStopping the Engine Mowing Tips Manual Transport Maintenance Maintenance For replacing BatteryFor cleaning Tire Pressures Safety SystemFuel Filter Parking brake adjustment Neutral Adjustments Deck Belt Removal Deck Belt InstallationDeck Belt Belts Belt InstallationPump Belt Replacing Pump BeltCutting Blades Adjusting the Mower Deck Leveling DeckAnti-scalp Rollers Deck Lift SpringUse protective glasses when cleaning and washing CleaningRemoval and Installation Caster WheelsGeneral LubricationLubrication Schedule Front Wheel Mount Wheel and Deck ZerksCables Front Wheel BearingsHydraulic Drive Fluid ChangePurging Procedures Troubleshooting guide Problem CauseTroubleshooting guide Winter Storage ServiceStorage Wiring Diagram Transmission Technical DataZPKW5426 ZPKW6029 Engine Dimension ZPKW5426 ZPKW6029 FrameStandard Hardware Torque SpecificationsHex Head Cap Screws Metric Standard HardwareUSA requirements CE requirementsAction Service JournalDelivery Service Stamp, signAfter 10 hours Date, mtr reading Stamp, signDaily Service Hour Service Service Journal Service Journal At least once each year Action Date, mtr reading Stamp, sign Service Journal Page 115 263226R1 09/21/09