Yazoo/Kees ZPKW5426 manual Roll Bar and Safety Belt, Before Starting

Page 27

OPERATION

Roll Bar and Safety Belt

Operate the unit with the roll bar in the raised and locked position and use the seat belt. There is no rollover protection when the roll bar is down. If it is necessary to lower roll bar, do not wear the seat belt. Raise the roll bar as soon as clearance permits.

WARNING!

The seat belt must be used when the roll bar is in upright position.

Before Starting

Read the sections Safety Instructions and Controls before starting the machine.

Perform the daily maintenance before starting (see maintenance schedule in the Maintenance section).

Check that there is sufficient fuel in the fuel tank.

Adjust the seat to the desired position.

The following conditions must be fulfilled before the engine can be started:

1.The blade switch for engaging the mower blades must be depressed.

2.The parking brake must be on.

8011-464

Roll bar in upright position

8065-006

Activate parking brake before starting

3. Both steering controls must be in the locked (outer) neutral position.

8065-018

Place controls in neutral position

27

Image 27
Contents Operator Manual Page Contents Page Introduction Manufacturing Number Good ServiceSymbols and decals Manual Performing any Safety Safety InstructionsGeneral Operation Never take passengers Slope Operation Personal Safety EquipmentChildren Safe Handling of Gasoline General Maintenance Risk of sparking Transport Spark Arrestors Rollover Protection System RopsControl Locations ControlsMotion Control Levers Tracking Hour MeterBlade Switch Ignition SwitchParking Brake Ignition switch RUN position Fuses Choke ControlCutting Height Pedals Fuel Shut Off Valve Seat Adjustment LeverRefueling Operation TrainingSteering Before Starting Roll Bar and Safety BeltStarting the Engine Set the throttle Turn to Start position Push choke in after starting Weak Battery Jumper CablesTo remove cables, reverse order Running Operating on Hills Ensure that no one is near mower when engaging blade switchStopping the Engine Mowing Tips Manual Transport Maintenance Maintenance Battery For cleaningFor replacing Safety System Fuel FilterTire Pressures Parking brake adjustment Neutral Adjustments Deck Belt Installation Deck BeltDeck Belt Removal Replacing Pump Belt Belt InstallationPump Belt BeltsCutting Blades Leveling Deck Adjusting the Mower DeckDeck Lift Spring Anti-scalp RollersCaster Wheels CleaningRemoval and Installation Use protective glasses when cleaning and washingLubrication Lubrication ScheduleGeneral Front Wheel Bearings Wheel and Deck ZerksCables Front Wheel MountFluid Change Hydraulic DrivePurging Procedures Problem Cause Troubleshooting guideTroubleshooting guide Service StorageWinter Storage Wiring Diagram Technical Data ZPKW5426 ZPKW6029 EngineTransmission ZPKW5426 ZPKW6029 Frame DimensionMetric Standard Hardware Torque SpecificationsHex Head Cap Screws Standard HardwareCE requirements USA requirementsStamp, sign Service JournalDelivery Service ActionDate, mtr reading Stamp, sign After 10 hoursDaily Service Hour Service Service Journal Service Journal At least once each year Action Date, mtr reading Stamp, sign Service Journal Page 115 263226R1 09/21/09