SETUP AND ADJUSTMENTS
WARNING!
No settings or adjustments are to be made unless: Engine is stopped, key has been removed, park brake is on and bat- tery cable removed from battery.
4.Torque all 1/2” hardware to 80 ft./lbs. (110 N•m).
5.Install and tighten knobs against the side post.
Setup
Uncrate machine.
ROPS Assembly
(Roll Over Protection System)
ROPS Assembly Components
1 - Top Loop
1 - Left Side Post
1 - Right Side Post
1 - Hardware Bag
2 - 1/2” Latch Pins w/lanyard
6 - 1/2C x 3 1/4” Cap screws
6 - 1/2C Centerlock Nuts
2 - Knobs
(all hardware Grade 5).
1.Remove roll bar and parts bag from the box.
2.Install roll bar side posts.
a.Locate the LEFT and RIGHT side posts.
b.Slilde the left side post into the left side receiver on the frame, do the same on the right side.
c.Using 1/2C x 3 1/4 cap screws, two per post, align the holes in the side post with the frame receiver.
d.Install the 1/2C centerlock nuts finger tight to the side post bolts.
3.Install roll bar top loop.
a.Align the holes of the top loop with the left and right side posts.
b.Slide the latch pins thru the front hole on the left and right side to connect the top loop to the side posts and secure with the hairpin.
c.Using 1/2C x 3 1/4 cap scrws thru the rear hole on the left and right side.
d.Install the 1/2C centerlock nuts finger tight.
LATCH PIN | TOP LOOP |
| KNOB |
1/2C X 3 1/4 |
|
CAPSCREW |
|
| 1/2C CENTERLOCK |
| NUT |
| RIGHT SIDE |
| POST |
LEFT SIDE |
|
POST | 1/2C CENTERLOCK |
| NUTS |
1/2C X 3 1/4 |
|
CAPSCREWS |
|
Tires |
|
Mount rear drive wheels using the lug nuts installed on the hubs.
Check the tire pressure in all four tires. All tires should be 15 psi.
15