Yard-Man 247.27432 Lubrication, Tires, Fuse, Pivot Points, Linkage, Steering Gear, Wheels, Engine

Page 23
Charging

Charging

If the unit has not been put into use for an extended period of time, charge the battery with an automotive-type 12-volt charger for a minimum of one hour at six amps.

WARNING: Batteries give off an explosive gas during and for some time after charging. Charge battery in a well ventilated area and do not allow a spark or an open flame near the battery.

TIRES

The recommended operating tire pressure is approximately 10 psi for the rear tires and 14 psi for the front tires. Refer to the tire sidewall for exact tire manufacturer’s recommended psi. Do not overinflate. Uneven tire pressure could cause the cutting deck to mow unevenly.

FUSE

A fuse is installed in your tractor’s wiring harness to protect the tractor’s electrical system from damage caused by excessive amperage. Always use the same capacity fuse for replacement. If the electrical system does not function, or your tractor’s engine will not crank, first check to be certain that the fuse has not blown. It can be found under the hood mounted behind the top of dash panel on the support bar. Pull the fuse out and compare it with Figure 22 to determine if it is good or bad.

GOODBAD

Figure 22

SECTION 11: LUBRICATION

WARNING: Always stop the engine and disconnect the spark plug wire(s) and ground against the engine before performing any maintenance.

ENGINE

Lubricate the engine with motor oil as instructed in the separate engine manual packed with your unit.

PIVOT POINTS

Lubricate all pivot points (AutoDrivepedal, brake pedal, etc.) at least once a season with light oil.

LINKAGE

Lubricate all the pivot points on the drive, brake and lift linkage at least once a season with SAE 30 engine oil.

STEERING GEAR

Lubricate the teeth of the steering gear with an all-purpose automotive grease every 25 hours of operation or once a season.

WHEELS

Both the front wheels and the rear wheels should be removed from the axles once a season. Lubricate the axles and the rims well with an all-purpose automotive grease before re-installing them.

FRONT AXLES

Your tractor may be equipped with zerk fittings on the ends of the front pivot bar. See Figure 10. Lubricate both the left and the right front axles with a grease gun at least once a season.

23

Image 23
Contents AutoDrive Lawn Tractor Models IMPORTANT READ SAFETY RULES AND INSTRUCTIONS CAREFULLYMTD PRODUCTS INC. P.O. BOX 368022 CLEVELAND, OHIO OPERATOR’S MANUALMTD PRODUCTS INC SECTION 1 TABLE OF CONTENTSSECTION 2 FINDING YOUR MODEL NUMBER SECTION 3 CALLING CUSTOMER SUPPORT1. GENERAL OPERATION SECTION 4 IMPORTANT SAFE OPERATION PRACTICES3. CHILDREN 4. SERVICE2. SLOPE OPERATION DO NOTFigure 1 Safety Labels found on your unit Slope Gauge SECTION 6 TRACTOR SET-UP SECTION 5 ATTACHMENTS & ACCESSORIESATTACHING THE BATTERY CABLES INSTALLING THE MULCH KITSECTION 7 CONTROLS CHOKE CONTROL IGNITION SWITCHINDICATOR MONITOR / HOUR METER THROTTLE CONTROL LEVERPARKING BRAKE BUTTON ELECTRIC PTO POWER TAKE-OFF KNOBLIFT LEVER AUTODRIVE PEDALCRUISE CONTROL BUTTON SEAT ADJUSTMENT LEVERSAFETY INTERLOCK SWITCHES SECTION 8 OPERATIONSTOPPING THE ENGINE SETTING THE CUTTING HEIGHTSETTING THE CRUISE CONTROL STARTING THE ENGINEOPERATING THE HEADLIGHTS USING THE LIFT LEVERENGAGING THE ELECTRIC PTO POWER TAKE-OFF KNOB DRIVING ON SLOPESFront to Rear SECTION 9 ADJUSTMENTSMOWING LEVELING THE DECKFront to Rear SEAT ADJUSTMENTSTEERING ADJUSTMENT Side to SideBRAKE ADJUSTMENT CARBURETOR ADJUSTMENTCUTTING DECK REMOVAL SECTION 10 MAINTENANCECLEANING THE ENGINE AND DECK ENGINE42-inch decks CHANGING THE DECK BELTS46-inch decks CHANGING THE TRANSMISSION DRIVE BELTSLower Drive Belt Front of TractorUpper Drive Belt Reassemble by following the above steps in reverse order CUTTING BLADES BATTERYPIVOT POINTS SECTION 11 LUBRICATIONTIRES FUSECorrective Action SECTION 12 TROUBLESHOOTING GUIDETrouble PossiblePage Model Electrical System/Tractor Body Fuel Cap For Two Gallon Tank, ShownIgnition Key Model Lift Assembly 3126 Plastic Flange w/ Fitting Not Shown Steering AssemblyModel Drive System Model Power Take-off System 42-inch Deck 46-inch DeckSpindle Assembly, 5.75 Dia Cutting DecksIntek Twin Briggs & StrattonKohler Single-cylinderEngine Accessories Other Warranties MANUFACTURER’S LIMITED WARRANTY FOR