!Mounting
Caution:
The NHT L5
Mounting L5
Studs
fig.6
Pivot Screw
To mount the L5, first remove the two pivot screws holding the bracket to the speaker (fig.7). Remove the mounting bracket from the L5. Place the mount- ing bracket on the wall and mark the locations for the two screws, making sure they are going into studs. Attach the mounting bracket to the wall. Reattach the speaker to the bracket with the two pivot screws, leaving the
screws slightly loose. Connect the wires to the speaker (read the next section ‘Connections’ first). Aim the speaker to the listening
position (see placement chapter) and tighten the pivot screws. Place the cover plates onto the speaker. The cover plates will secure to the speaker via the magnets on the bracket
fig.7 | Cover Plate |
| |
| Magnet |