Yard-Man 109T To Stop Engine And Blade, To De-Energize Self Starter, Using Your Rotary Mower

1.Check oil level and add fuel, if necessary.

2.Open shut off valve (if equipped) 1/4 turn.

3.Turn safety key 1/4 turn clockwise to RUN position.

4.Firmly push primer bulb 3 times (For a cold engine only!).

5.While standing at upper handle, depress the starter control button with the thumb of your right hand.

6.Using your left hand, pull the blade control handle all the way toward the upper handle. See Figure 7. Starter will de-energize and engine will start.

(NOTE: If engine does not start, release the blade control handle and follow steps 8, 9, 10,11 and 12 in the “First Time Starting Engine” instructions.)

NOTE: If any problems are encountered, refer to the Trouble Shooting Guide for helpful information.

To Stop Engine And Blade

1.Release safety blade control handle (the start control button will automatically return to the off/up position), engine and blade will stop within a few seconds.

NOTE: Engine may stop with a ratcheting sound. This sound is the self starter being reactivated/energized for the next start.

2.Turn safety key 1/4 turn counterclockwise to LOCK position. Remove key and store in a safe place.

WARNING: The blade will continue to rotate for three seconds after the blade control lever is released.

To De-Energize Self Starter

•Remove spark plug wire from spark plug.

•Turn safety key to RUN position (1/4 turn clockwise).

•While standing in the operating position, depress the starter control button fully with the thumb of your right hand.

•Using your left hand, pull the control handle all the way toward the upper handle. (Release button and wait until engine and starter stop rotating.)

•Release safety blade control handle (the start control button will automatically return to the off/up position.)

•Remove safety key.

NOTE: Engine will crank over upon actuating equipment starting controls, but will not spark if spark plug wire was removed from spark plug as described above. Once engine has stopped cranking, self starter is de-energized.

WARNING: Self Starting System: If these instructions are not followed, amputation or severe laceration can result.

•ALWAYS disconnect spark plug, de-energize starter, lock and remove safety key BEFORE performing ANY service to the engine or mower.

•DO NOT attempt any maintenance or repairs to the self starter.

•NEVER assume starter is de-energize, even if key is in LOCK AND REMOVE position and/or removed from engine.

•BEFORE removing grass or other debris from under mower deck; BEFORE changing oil, air filter or spark plug; BEFORE removing blade for servicing; BEFORE performing any other service to engine or mower; BEFORE transporting mower-

ALWAYS DE-ENERGIZE SELF STARTER.

•ALWAYS lock and remove safety key and store in a safe place until next use. The safety key is designed and intended to be removed from engine when not in use. Removing key will prevent unsupervised or unexpected starting of mower by children or unsuspecting adults. The safety key must be in the locked position before it can be removed.

Using Your Rotary Mower

•Thoroughly inspect the area where the equipment is to be used. Remove all stones, sticks, wire, bones, toys and other foreign objects which could be tripped over or picked up and thrown by the blade. Thrown objects can cause serious personal injury.

•For best results, do not cut wet grass because it tends to stick to the underside of the mower, preventing proper discharge of grass clippings, and could cause you to slip and fall. New grass, thick grass or wet grass may require a narrower cut.

•When using side-discharge mower, the best mowing pattern is one that allows the clippings to discharge towards the uncut part of the lawn. This permits recutting of the clippings to further pulverize them. When cutting high weeds, discharge towards cut portion, then recut at right angles to first direction.

•For a healthier lawn, always cut off one-third or less of the total length of the grass. Lawn should be cut in the fall as long as there is growth.

WARNING: If you strike a foreign object, stop the engine. Remove wire from spark plug and de-energize, thoroughly inspect the mower for any damage, and repair the damage before restarting and operating the mower. Excessive vibration of the mower during operation is an indication of damage. The unit should be promptly inspected and repaired.

10