Yard-Man 106D manual To Stop Engine And Blade, To De-EnergizeSelf Starter, Using Your Rotary Mower

Page 10
To Stop Engine And Blade

NOTE: If any problems are encountered, refer to the Trouble Shooting Guide for helpful information.

To Stop Engine And Blade

1.Release safety blade control handle (the start control button will automatically return to the off/up position), engine and blade will stop within a few seconds.

NOTE: Engine may stop with a ratcheting sound. This sound is the self starter being reactivated/energized for the next start.

2.Turn safety key 1/4 turn counterclockwise to LOCK position. Remove key and store in a safe place.

WARNING: The blade will continue to rotate for three seconds after the blade control lever is released.

To De-Energize Self Starter

Remove spark plug wire from spark plug.

Turn safety key to RUN position (1/4 turn clockwise).

While standing in the operating position, depress the starter control button fully with the thumb of your right hand.

Using your left hand, pull the control handle all the way toward the upper handle. (Release button and wait until engine and starter stop rotating.)

Release safety blade control handle (the start control button will automatically return to the off/up position.)

Remove safety key.

NOTE: Engine will crank over upon actuating equipment starting controls, but will not spark if spark plug wire was removed from spark plug as described above. Once engine has stopped cranking, self starter is de-energized.

WARNING: Self Starting System: If these instructions are not followed, amputation or severe laceration can result.

ALWAYS disconnect spark plug, de-energize starter, lock and remove safety key BEFORE performing ANY service to the engine or mower.

DO NOT attempt any maintenance or repairs to the self starter.

NEVER assume starter is de-energize, even if key is in LOCK AND REMOVE position and/or removed from engine.

BEFORE removing grass or other debris from under mower deck; BEFORE changing oil, air filter or spark plug; BEFORE removing blade for servicing; BEFORE performing any other service to engine or mower; BEFORE transporting mower-

ALWAYS DE-ENERGIZE SELF STARTER.

ALWAYS lock and remove safety key and store in a safe place until next use. The safety key is designed and intended to be removed from engine when not in use. Removing key will prevent unsupervised or unexpected starting of mower by children or unsuspecting adults. The safety key must be in the locked position before it can be removed.

Using Your Rotary Mower

Be sure that lawn is clear of stones, sticks, wire, or other objects which could damage lawn mower or engine. Such objects could be accidently thrown by the mower in any direction and cause serious personal injury to the operator and others.

For best results, do not cut wet grass because it tends to stick to the underside of the mower, preventing proper discharge of grass clippings, and could cause you to slip and fall. New grass, thick grass or wet grass may require a narrower cut. Speed of the mower should be adjusted to the condition of the lawn.

For a healthier lawn, always cut off one-third or less of the total length of grass. Lawn should be mowed in the fall season as long as there is growth.

WARNING: If you strike a foreign object, stop the engine. Remove wire from spark plug and de-energize, thoroughly inspect the mower for any damage, and repair the damage before restarting and operating the mower. Extensive vibration of the mower during operation is an indication of damage. The unit should be promptly inspected and repaired.

10

Image 10
Contents Operator’s Manual MODEL 106DMTD LLC, P.O. BOX 361131 CLEVELAND, OHIO 20 Self Starter Mulching Push Lawn MowerFINDING MODEL NUMBER TABLE OF CONTENTSContent ENGINE INFORMATIONSECTION 1 IMPORTANT SAFE OPERATION PRACTICES General OperationSlope Operation ServiceGeneral Service ChildrenYour Responsibility WARNING STARTERSECTION 2 SLOPE GAUGE To Remove Unit From Carton Disconnect Spark Plug WireSECTION 3 ASSEMBLING YOUR LAWN MOWER Tools RequiredCutting Height Adjustment Lever Cutting Height Adjustment LeverSafety Key Safety Key Mulching Plug FigureGas and Oil Fill-Up Adjusting Cutting HeightSECTION 5 OPERATING YOUR LAWN MOWER Before StartingTo Stop Engine And Blade Using Your Rotary MowerTo De-EnergizeSelf Starter Carburetor SECTION 6 MAKING ADJUSTMENTSHandle Height Cutting HeightLubrication To Reinstall BladeSECTION 7 MAINTAINING YOUR LAWN MOWER Cutting BladeEngine Cutting DeckSECTION 8 OFF-SEASONSTORAGE Possible Causes SECTION 9 TROUBLE SHOOTING GUIDETrouble Corrective ActionPage SECTION 10 PARTS LIST MODEL 106D Ref. No Model 106DDescription Page Page MANUFACTURER’S LIMITED WARRANTY FOR