Stiga 46 S EURO manual Starting the Engine Briggs & Stratton

ENGLISH

Honda:

Remove and wipe off the dipstick (fig. 7). Insert the dipstick fully, but do not screw it into the thread. Pull it up again. Read off the oil level. If the oil level is low, fill with oil up to the ‘FULL/MAX’ mark.

FILL UP THE PETROL TANK

Never remove the filler cap or fill with petrol while the engine is running or still warm.

Never completely fill the petrol tank. Al- low a little room for the petrol to expand if necessary.

Some engines have an extra safety cover under the regular fuel cap. This must not be reinstalled.

Preferably use an environmentally friendly petrol, i.e. alkylate petrol. This type of petrol has a com- position that is less harmful to people and nature. It has e.g. no lead additives, no oxygenators (alco- hols and ethers), no alkenes and no benzene.

NOTE! If you change to environmental- ly friendly petrol in an engine previously run on ordinary lead-free petrol (95), the petrol manufacturer’s recommenda- tions must be followed carefully.

Ordinary lead-free 95 octane petrol can also be used. You must never use 2-stroke petrol mixed with oil. NOTE! Bear in mind that ordinary lead- free petrol is a perishable; do not purchase more petrol than can be used within thirty days.

STARTING THE ENGINE (Briggs & Stratton)

1.Place the lawnmower on flat, firm ground. Do not start in long grass.

2.Make sure the spark plug cable is connected to the spark plug.

3.If the lawnmower is equipped with throttle con-

trol, set the throttle control N to full throttle (fig. 8, 9).

4.When starting a cold engine: Press down the primer fully 6 times (fig. 10, 11).

When starting a warm engine the primer does not need to be used. If the engine stops due to a lack of fuel, refill and press down the primer 3 times.

5.Press the Start/Stop loopG towards the handle. NOTE! The Start/Stop loopG must be kept pressed in to prevent the engine stopping (fig. 8, 9).

6.For ease of starting, press down the handle so that the front wheels lift slightly from the ground. Do not start in thick grass.

Multiclip 46 SGrasp the starter handle and start the engine by pulling briskly on the starter cord.

Multiclip 46 SE: Start the engine by turning the ignition key clockwise. Release the key as soon as the engine starts. Always make short at- tempts at starting in order to prevent the battery running down.

7.For the best mowing results, the engine should always be driven at full throttle.

Keep hands and feet away from the ro- tating blade. Never put your hand or foot under the blade casing or in the grass ejector while the engine is run- ning.

STARTING THE ENGINE (Honda)

1.Place the lawnmower on flat, firm ground. Do not start in long grass.

2.Make sure the spark plug cable is connected to the spark plug.

3.Open the fuel tap (fig. 12).

4.Move the throttle control N to the choke posi-

tion . NOTE! It is not necessary to use the choke position when the engine is warm (fig. 8).

5.Press the Start/Stop loopG towards the handle. NOTE! The Start/Stop loopG must be kept pressed in to prevent the engine stopping (fig. 8).

6.Grasp the starter handle and start the engine by pulling briskly on the starter cord.

7.When the engine starts, move the throttle con- trol backwards until max. revs are obtained. NOTE! The engine should always be run at maximum revs to avoid abnormal machine vi- brations.

Keep hands and feet away from the ro- tating blade. Never put your hand or foot under the blade casing while the en- gine is running.