GB | ENGLISH |
|
|
ENGAGING/DISENGAGING THE DRIVE
Engaging the drive is facilitated by pressing down the handlebar so that the driving wheels are raised slightly from the ground.
Engage the drive by pressing the clutch loop I to- wards the handle. Disengage the drive by releasing the clutch loop I (fig. 8, 9).
By allowing the driving wheels to be raised slight- ly from the ground, turning, reversing, moving round trees, etc., can be performed without having to disengage the drive system.
STOPPING THE ENGINE
The engine may be very warm immedi- ately after it is shut off. Do not touch the silencer, cylinder or cooling fins. This can cause burn injuries.
1.Release Start/Stop loop G to stop the engine (fig. 8, 9). This loop must not be disengaged (e.g. by setting it in the depressed position against the handle), as it will not be possible to stop the engine.
Honda: Close the fuel tap.
2.If the lawnmower is left unattended, remove the spark plug cable from the spark plug.
Multiclip 46 SE: Also remove the starter key.
If the start/stop loop ceases to work, stop the engine by removing the spark plug cable from the spark plug. Immediately take the lawnmower to an authorised workshop for repair.
DRIVING TIPS
Before mowing the lawn, take care to remove any stones, toys and other hard objects.
A machine with the MULTICLIP system cuts the grass, chops it finely and then blows it down into the lawn. The grass clippings need not be collected.
The following rules should be observed to give the best MULTICLIP effect:
1.Use a high engine speed (full throttle).
2.Do not cut the grass too short. Not more than 1/ 3rd of the length should be cut off.
3.Ensure that the area under the mower casing is always kept clean.
4.Always use a
5.Avoid mowing when the grass is wet. The grass sticks more easily to the underside of the cas- ing, giving poorer mowing results.
CUTTING HEIGHT
Shut off the engine before adjusting the cutting height.
Do not set the cutting height so low that the blades come into contact with une- ven ground.
The lawnmower has rapid setting with 4 cutting heights on the front wheels.
It is possible to vary the rear cutting height by moving the wheel axle through four positions (fig. 13).
Make sure that you have the same cutting height set on all wheels.
MAINTENANCE
No servicing is to be carried out on the engine or mower unit without first switching off the engine and removing the spark plug cable from the spark plug.
Multiclip 46 SE: No servicing may be carried out on the engine or mower unit without disconnecting the battery termi- nal from the terminal on the motor (fig. 4).
Stop the engine and remove the spark plug cable if the mower is to be lifted, e.g. during transportation.
If the machine needs to be tilted, the fuel tank must be emptied and the engine’s spark plug kept upright.
CLEANING
After use, the mower should be cleaned. This is particularly important on the underside of the mower casing. Rinse clean with the garden hose. The mower will then last longer and work better.
NOTE!