Williams Sound WIR TX925 specifications Dimension Foot Pattern

SoundPlus® Infrared System • Model WIR TX925

SoundPlus® Infrared System • Model WIR TX925

D

Fig. 5: 3-Dimension Foot Pattern

The TX9 floods the listening audience with a cone shape light pattern as shown here.

The path of the cone shape light leaves a pattern on the ground, or "foot print, " and indicates where the strongest receiver reception will occur.

The actual coverage area will vary depending on the sensitivity of the receiver being used. Refer to Figures 4 and 7 to determine how many emitters are required for 100% coverage of the listening area.

To determine the best location for the emitter, it helps to think of the IR emitter as an invisible flood- light. You’ll want to aim it so the listeners are “flooded” with the infrared light. The emitter should also be positioned high enough so it won’t be blocked by people and other physical obstructions. See Figure 6 below. Mount the emitter at least 2 ft. (.61 m) above the audience. Position the emitter to face in a slightly downward angle, 20°, that will increase the “throw” of the infrared beam.

Fig. 6: Vertical Beam Spread

Minimum Receiver Range When Operating with a TX9 Emitter in Single Channel Mode
RX22-4 Receiver:	RX14-2: 80' (24 m)	RX16: 70' (21 m)
150' (45 m)
	(Range)
		TX9
		30'
		SCREEN
6'
		STAGE

NOTE: SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE!

©2006, Williams Sound Corp. CAT 097G 4