ENGLISH | GB |
|
|
SYMBOLS
The following symbols are displayed on the ma- chine in order to remind you about the safety pre- cautions and attention necessary when using the machine.
The symbols mean:
Warning!
Read the instruction book and safety man- ual before using the machine.
Warning!
Do not put hands or feet under the cover of the machine when it is running.
Warning!
Beware of objects being flung out. Keep spectators away.
ASSEMBLY
MOWER DECK
1.Bolt the mower deck to the attachment brackets D (fig 5a).
2.Then hook the lower
3.Connect the electrical contact to the outlet on the side of the machine (applies only to art. no. 13- 2921), (fig. 6).
V - BELT
1.Set the height adjustment to an intermediate posi- tion.
2.Lift the mower deck using the attachment lift.
3.Pull the
Warning!
Before starting any repair work, remove the spark plug cable from the spark plug.
INTRODUCTION
This mower deck can only be used for Park ma- chines with a motor output of at least 16 hp.
The mower deck is available in two versions as standard:
-with mechanical setting of the mowing height (art. no.
-with
PREPARATIONS
Park models up to 1993:
A modification must be made to the machine to use the mower deck:
1.Dismantle the return spring for centre steering (fig 1).
2.Saw off the spring bracket, level with the frame side member (fig 2).
3.Drill a new hole (Ø 8 mm), 8 mm from the lower edge of the frame side member (fig 3).
4.Fit the spring in the new hole (fig 4).
4.Tension the belt using the tension roller G. The tension roller should be on the left of the belt seen from the operator's position.
5a. Park
Hook the tension roller spring H into the floor on the right hand side (fig 7).
5b. Park
Hook the tension roller spring H into the fastener, just behind the front right wheel (fig 7).
SETTING
For the attachment to mow evenly and cleanly it needs to be adjusted correctly:
1.Make sure the tyre pressure is correct: Front: 0.6 bar (9 psi).
Rear: 0.4 bar (6 psi).
2.Place the machine on a flat surface. Loosen the screws I (fig 8).
3.Adjust the mower deck so that the casing's front and rear edges are the same height from the floor.
4.Tighten the screws.
USE
MOWING HEIGHT
The mowing height may vary from 30 to 80 mm: - art. no.
5