How to Connect for Mono Parallel, AWG cables

How to Connect for Mono Parallel

1.Connect the Power Control Cable from the Control Center Amp ON to the MCC602TM ON connector on

the right side of the amplifier.

Note: All cables should be connected to the amplifier before connecting the DC power cables to the battery.

2.Connect a cable from a McIntosh Control Center with Power Guard to the MCC602TM PG connector on the right side of the amplifier.

3.Connect cables from the amplifier’s CHANNEL 2 (+) and (-) OUTPUT terminals to the CHANNEL 1 (+) and

(-) OUTPUT terminals.

Note: In Mono Parallel Mode, the impedance presented to the speaker is half of the number marked on the terminals, refer to the Mono Parallel Hookup Connections chart.

4.Connect a cable from a first Subwoofer’s (+) and (-) Terminals to the Amplifier’s (+) and (-) Terminals of the CHANNEL 2 OUTPUT.

5.Connect a cable from the first Subwoofer’s (+) and (-) Terminals to the Second subwoofer’s (+) and (-) Termi- nals.

6.Connect audio cables from a McIntosh Control Center to the INPUTs of a McIntosh Crossover Network.

7.Connect audio cables from the McIntosh Crossover Network SUB OUTPUT to the MCC602TM 2/MONO Input.

McIntosh Control Center

Note: Do not connect a cable to the LEFT input.

8.Connect the MCC602TM DC input terminals to the vehicle battery terminals using a minimum size of 4

AWG cables.

Note: It is advisable to place an inline fuse of sufficient size as close as possible to the battery. An alternative configuration is, when the MCC602TM is set for MONO

,PSHGDQFH6DNHURKPV0RQRPARALLEL,3DUDOOHO6SHDNHU&+both287387&RQRKP$DQG11(/6channels+RRNHFWLRQHJDWLYHXScan&RQQHFWLRQVbe6SHDNHUfed 287387+from&RQQHFWRKP$DQG11(/6the3RWLYH2/MONOLRQ Input and each drive a separate speaker. In this case the

speakers are connectedRQQHFWLRQVas described in the HOWFWLRQVTO CONNECT FOR TWO CHANNEL section of this manual on page.

Left Front Output

Right Front Output

Power Guard

(orange)

Amp ON (blue/white)

McIntosh Crossover Network