McIntosh MCC602TM manual Specifications

Page 18

Specifications

Specifications

Power Output Stereo

Minimum sine wave continuous average power output per channel, all channels operating is:

300 watts into 2 ohm load

300 watts into 4 ohm load

300 watts into 8 ohm load

Power Output Mono

Minimum sine wave continuous average power output per channel, all channels operating is:

600 watts into 1 ohm load

600 watts into 2 ohm load

600 watts into 4 ohm load

Rated Power Band

20Hz to 20,000Hz

Total Harmonic Distortion

Maximum Total Harmonic Distortion at any power level from 250 milliwatts to rated power output is: 0.005% for 2, 4 or 8 ohm loads (Stereo)

0.005% for 1, 2 or 4 ohm loads (Mono)

Dymanic Headroom 1dB

Frequency Response

+0, -0.25dB from 20Hz to 20,000Hz +0, -3dB from 10Hz to 50,000Hz

Sensitivity

1Volt balanced or unbalanced inputs

A-Weighted Signal To Noise Ratio 114dB (2V)

Intermodulation Distortion

Maximum Intermodulation Distortion if instanta- neous peak output per channel does not exceed twice the rated output, for any combination of fre- quencies from 20Hz to 20,000Hz, with all channels operating is:

0.005% for 2, 4 or 8 ohm loads (Stereo)

0.005% for 1, 2 or 4 ohm loads (Mono)

Input Impedance

15,000 ohms balanced or unbalanced inputs

Power Requirements

12 Volts DC, 3.5 amps (idle) - 100 amps (600 watts)

Dimensions

26-7/8 inches (68.3cm) wide, 12-1/2 inches (31.75 cm) depth, 4-3/16 inches (10.64 cm) high

Weight

50.5pounds (22.9 Kg) net, 58.5 pounds (26.5 Kg) in shipping carton

18

Image 18
Contents MCC602TM Owner’s ManualConnection InstallationGeneral Care of EquipmentThank You Customer ServiceTable of Contents Please Take a MomentPerformance Features General Notes, con’tIntroduction 16-7/8 10-1/3225.46cm Removing the Glass Panel InstallationAmplifier Ventilation Removing the End CapsRight Side View How to Connect for Two Channels Nals using a minimum size of 4 AWG cablesFuse How to Connect for Mono Parallel AWG cablesWoofer 4 Ohm Page Power Output Meters PowerMode Switch Input Sensitivity ControlsIllumination, the power control and the power How to Replace the FusesHow to Replace the Fuses Refer to figures 7, 8Technical Description Design PhilosophyAutoformers Expectancy for the amplifierTechnical Description, con’t Engineers know how to do it rightPower Supply Protection CircuitsSpecifications Packing Instructions