Stanley Black & Decker DS11 user manual Replacing the Chain Breaker Punch, Spinning Rivets

Page 16

MAINTENANCE & ADJUSTMENTS

REPLACING THE CHAIN BREAKER PUNCH

If the chain breaker punch (P/N 22801) becomes worn or damaged, use the following procedures for replace- ment.

1.Remove the punch by loosening the set screw (Fig- ure 14).

Figure 14. Removing the Punch

2.Insert a new punch into the holder and push it up until it is fully seated (Figure 15). Secure the punch to the chain breaker holder by fully tightening the set screw.

Figure 16. Rivet Spinner Mounting

2.Lay the chain across the plastic chain supports and then rotate the supports so the rivet head is cen- tered between the take-up handle pocket and the spinner anvil (Figure 17).

Figure 17. Positioning the Chain

3.Turn the take-up handle until the chain is tight against the spinner anvil (Figure 18).

Figure 15. Replacing the Punch

SPINNING RIVETS

The following procedures explain how to spin rivets us- ing Stanley’s bench-mounted rivet spinner (P/N 20857) to assembly the chain.

1.Mount the rivet spinner flush with the side or front of a flat, clean work surface (Figure 16).

Take-up

Rivet SpinnerHandle

Crank

Figure 18. Securing the Chain

4.Turn the rivet spinner crank a few times to center the rivet hub in the spinner anvil (Figure 19).

16 ► DS11 User Manual

Image 16
Contents DS11 Declaration of Conformity Weisbeck, AndyTable of Contents Safety Symbols Local Safety RegulationsSafety Precautions Safety Precautions 108 Tool Stickers & TagsHose Safety Tags Hose TypesHose Recommendations Tool to Hydraulic Circuit Hose RecommendationsHtma / Ehtma Requirements Htma / Ehtma RequirementsPreoperation Procedures OperationOperating Procedures NEW SAW Chain BREAK-INCutting Tips Plan the CUTCold Weather Operation Maintenance & Adjustments General Maintenance TipsChain Tension Adjustment SAW BAR RailServicing the Chain Chain Breaker MountingReplacing the Chain Breaker Punch Spinning RivetsSpinner Oiling Chambers Tool Protection & Care Troubleshooting Problem Cause RemedySpecifications AccessoriesDS11 Parts Illustration DS11 Parts List OIL TubeDS11 Motor Parts List Denotes Used on Under Water ModelonlyDiamond Chain Applications Model BAR Length Correct ApplicationsUnderwater Models only Underwater Tools Depth GuidelineGPM