How to Connect for Four Channels
How to Connect for Four Channels
1.Connect the cable from the Control Center Amp On to the MCC404/MCC404M ON Connector on the right
side of the amplifier.
Note: All cables should be connected to the amplifier before connecting the DC power cables to the battery.
2.Connect a cable from a McIntosh Control Center with Power Guard to the MCC404/MCC404M PG Connec- tor on the right side of the amplifier.
3.Connect cables (up to 12AWG) from four separate loudspeakers, to the Amplifier’s Channels 1, 2, 3 and 4 Terminals, being careful to observe the correct polari- ties.
4.Connect audio cables from the Control Center Outputs to the MCC404/MCC404M Inputs 1, 2, 3 and 4.
5.Optional Connection allows the SUB Outputs to be connected to a separate Subwoofer Power Amplifier, regardless of the MCC404/MCC404M Operating Mode used.
Note: The Subwoofer Outputs are
6.Optional Connection allows the SUB REMOTE CON- TROL to be connected to the Power Amplifier, regard- less of the MCC404/MCC404M Operating Mode used.
7.Connect the MCC404/MCC404M to the vehicle bat-
tery terminals using size 4 AWG (Maximum) cables.
Note: It is advisable to place an
|
| Subwoofer |
| Right Rear Output | Loudspeaker |
|
| |
McIntosh Control Center | Left Rear Output |
|
| Left Front Output | Optional Subwoofer Amplifier |
| Right Front Output | |
|
|
Right Front Loudspeaker
Right Rear Loudspeaker
Left Front Loudspeaker
-Vehicle + Battery
Fuse
Left Rear
Loudspeaker
8