Shindaiwa 62640-94313 manual This Warranty is Administered by

Page 17

The following statement only applies to United States and its territories

Shindaiwa Corporation

Federal Emission Design And Defect Limited Warranty

Utility And Lawn And Garden Engines

Shindaiwa Corporation warrants to the initial purchaser and each subsequent owner, that this utility equipment engine (herein engine) is designed, built and equipped to conform at the time of initial sale, to all applicable regulations of the U.S. Environmental Protection Agency (EPA), and that the engine is free of defects in materials and workmanship that would cause this engine to fail to conform with EPA regulations during its warranty period. This emission warranty is applicable in all States, except the State of California.

For parts listed under PARTS COVERED, the dealer authorized by Shindaiwa Corporation will, at no cost to you, make the neces- sary diagnosis, repair, or replacement of any defective emis- sion-related component to ensure that the engine complies with applicable U.S. EPA regulations.

MANUFACTURERS WARRANTY COVERAGE

When sold within the U.S., this engine’s emission control system is warranted for a period of two (2) years from the date this product is first delivered to the original retail purchaser.

OWNER’S WARRANTY RESPONSIBILITIES

As the engine owner, you are responsible for the performance of the required maintenance listed in your owner’s manual. Shindaiwa Corpora- tion recommends that you retain all receipts covering maintenance on your engine, but Shindaiwa Corporation cannot deny a warranty claim solely for the lack of receipts or for your failure to ensure the perfor- mance of all scheduled maintenance.

As the engine owner, you should however be aware that Shindaiwa Corporation may deny your warranty coverage if your engine or a part has failed due to abuse, neglect, improper maintenance or unapproved modifications.

You are responsible for presenting your engine to the nearest dealer authorized by Shindaiwa Corporation when a problem exists.

If your Shindaiwa Dealer is unable to answer questions regarding your warranty rights and responsibilities, you should then contact your Shindaiwa Distributor.

For the name and telephone number of the Shindaiwa Distributor in your area, please call Shindaiwa Inc. at (503) 692-3070 between the hours of 8:00 AM and 5:00 PM Pacific Standard Time.

PARTS COVERED

Listed below are the parts covered by the Federal Emission Design and Defect Warranty. Some parts listed below may require scheduled main- tenance and are warranted up to the first scheduled replacement of that part. The warranted parts include:

1.Carburetor Internal Components

Jet, Diaphragm Assembly-Metering

2.Ignition System Components

Ignition Coil

Flywheel Rotor

The emission control system for your particular Shindaiwa engine may also include certain related hoses and connectors.

MAINTENANCE AND REPAIR REQUIREMENTS

You are responsible for the proper use and maintenance of the engine. You should keep all receipts and maintenance records covering the performance of regular maintenance in the event questions arise. These receipts and maintenance records should be transferred to each subse- quent owner of the engine. Shindaiwa Corporation reserves the right to deny warranty coverage if the owner has not properly maintained the engine. Shindaiwa Corporation will not deny warranty repairs, however, solely because of the lack of repair, maintenance or failure to keep main- tenance records.

MAINTENANCE, REPLACEMENT OR REPAIR OF EMISSION CONTROL DEVICESANDSYSTEMSMAYBEPERFORMEDBYANYREPAIRESTAB- LISHMENT OR INDIVIDUAL; HOWEVER, WARRANTY REPAIRS MUST BE PERFORMED BY A DEALER OR SERVICE CENTER AUTHORIZED BY SHINDAIWA CORPORATION THE USE OF PARTS THAT ARE NOT EQUIVALENT IN PERFORMANCE AND DURABILITY TO AUTHORIZED PARTS MAY IMPAIR THE EFFECTIVENESS OF THE EMISSION CON- TROL SYSTEM AND MAY HAVE A BEARING ON THE OUTCOME OF A WARRANTY CLAIM.

If other than the parts authorized by Shindaiwa Corporation are used for maintenance replacements or for the repair of components affecting emission control, you should assure yourself that such parts are war- ranted by their manufacturer to be equivalent to the parts authorized by Shindaiwa Corporation in their performance and durability.

OBTAINING WARRANTY SERVICE

All repairs qualifying under this limited warranty must be performed by a dealer authorized by Shindaiwa Corporation

If any emission-related part is found defective during the warranty period, it is your responsibility to present the product to an authorized Shindaiwa dealer. Bring your sales receipts showing the date of pur- chase for this engine. The dealer authorized by Shindaiwa Corporation will perform the necessary repairs or adjustments within a reasonable amount of time and furnish you with a copy of the repair order. All parts and accessories replaced under this warranty become the property of Shindaiwa Corporation

To locate an authorized Shindaiwa dealer near you, contact your Shindaiwa Distributor. For the name and telephone number of the Shindaiwa Distributor in your area, please call Shindaiwa Inc. at (503)

692-3070 between the hours of 8:00 AM and 5:00 PM Pacific Standard Time.

THIS WARRANTY IS ADMINISTERED BY

Shindaiwa Inc.

11975 S.W. Herman Rd. Tualatin OR. 97062 (503) 692-3070

LIMITATIONS

The Federal Emission Design and Defect Warranty shall not cover any of the following:

(a)conditions resulting from tampering, misuse, improper adjust- ment (unless they were made by the dealer or service center authorized by Shindaiwa Corporation during a warranty repair), alteration, accident, failure to use the recommended fuel and oil, or not performing required maintenance services,

(b)the replacement parts used for required maintenance services,

(c)consequential parts used for required maintenance services,

(d)diagnosis and inspection fees that do not result in eligible war- ranty service being performed, and

(e)any non-authorized replacement part, or malfunction of autho- rized parts due to use of non-authorized parts.

17

Image 17
Contents AH2510 Articulated Hedge Trimmer Introduction ContentsSafety Instructions Operating Precautions Safety Equipment and LabelsSecure long hair so it is above shoulder level Operating the Articulated Hedge TrimmerProduct Description Prior To AssemblySpecifications Throttle Cable Assembly AH2510Adjusting the Hedge Trimmer Cutter Assembly Assembly Adjust Throttle Lever Free PlayMixing Fuel Adjusting the Cutter Assembly for Storage or TransportationFilling the Fuel Tank Examples of 501 mixing quantitiesStarting a Flooded Engine When the Engine StartsStarting the Engine Stopping the Engine Adjusting Engine IdleIdle Speed Adjustment Daily Maintenance General MaintenanceMuffler Spark PlugHour Maintenance Cutter Blade Adjustment10/15-Hour Maintenance Every 10 to 15 hours of operationServicing the fuel filter 139/150-Hour MaintenanceValve Adjustment Long Term Storage Spark Arrester Screen MaintenanceWhat To Check Troubleshooting GuidePossible Cause RemedySymptom Possible Cause Remedy Additional ProblemsThis Warranty is Administered by Page

62640-94313 specifications

Shindaiwa 62640-94313 is a premier product renowned for its advanced technology and reliable performance. This high-quality component is primarily designed for outdoor power equipment, catering to both professional landscapers and those who maintain their own lawns. Its robust construction and innovative features make it a go-to choice for anyone looking to enhance their gardening tools.

One of the standout characteristics of the Shindaiwa 62640-94313 is its ergonomic design, which ensures ease of use over extended periods. The handle is crafted to provide a comfortable grip, reducing user fatigue when performing repetitive tasks. This attention to user comfort, combined with the lightweight nature of the unit, allows for effortless maneuverability.

In addition to comfort, the Shindaiwa 62640-94313 boasts powerful performance capabilities driven by its durable engine. This high-performance engine provides ample power for a variety of outdoor applications, ensuring that users can tackle any gardening or landscaping challenge with confidence. The engine is designed to deliver a reliable start and consistent operation, a critical feature when working on larger or more complex tasks.

Another important aspect of the Shindaiwa 62640-94313 is its advanced emissions technology, which aligns with modern environmental regulations. The product minimizes harmful emissions while maximizing fuel efficiency, making it an eco-friendly choice for conscientious users. This balance of power and environmental responsibility sets the Shindaiwa 62640-94313 apart in today's competitive market.

The construction of this component incorporates high-grade materials that enhance durability, ensuring that it can withstand the rigors of frequent use. Whether it's trimming, edging, or clearing, the Shindaiwa 62640-94313 is built to last, providing reliability in various outdoor conditions.

Maintenance is also straightforward, which is a crucial feature for busy professionals and homeowners alike. Easy access to key components simplifies upkeep, allowing users to focus more on their tasks rather than spending excessive time on preventative measures.

In summary, the Shindaiwa 62640-94313 is an exceptional product that combines comfort, power, and durability. Its user-friendly design and eco-conscious performance make it a top choice for anyone seeking a reliable tool for outdoor work. Whether for commercial use or personal projects, the Shindaiwa 62640-94313 is engineered to meet the challenges of modern landscaping head-on.