Servis-Rhino F-4123C manual SL-33

Page 14
(SL-35)
(SL-30)
(SL-29)
(SL-25)
(SL-18)

SAFETY

SAFETY

Know before you DIG. Call 888-258-0808 and request that all buried utilities locations be identified before digging in unfamiliar ground. Do not let the loader or attachment contact buried electrical power lines, utilities or gas lines. Contact with electrical power lines can result in serious bodily injury or electrocution. If the loader contacts a power line, remain in the tractor seat until the power has been shut off. Stepping off the tractor can permit electrical current to pass through the body resulting in electrocution.

Do not use loader as a jack to raise the tractor tires off the ground. The loader could fail causing the tractor and loader to fall to the ground resulting in serious injury.

Use extreme care when loading, transporting or dumping loads that impair or partially block the operator’s line of sight. Know where you are traveling. Make sure no bystanders are in the area of travel. If a bystander assists in providing guidance, make sure they are not in the path of travel. Keep all bystanders 25 feet away from travel path.

Always look behind you before backing up. Make sure you are looking in the direction of travel. A bystander could walk behind the tractor. Running into a bystander can result in serious injury or death.

Some tractors are equipped with a “Super Steer” front axle. When a loader is mounted to this type of tractor, the bucket will shift in the opposite direction from which the wheels are turned. Maximum shift will be approximately 8 inches and most noticeable when the tractor is stationary. Sudden or unexpected movement of the loader and attachment could result in serious injury to the operator or bystanders.

(SL-33)

Operate the tractor and loader only in conditions where you have clear visibility in daylight or with adequate artificial lighting. Never operate in darkness or foggy conditions where you cannot clearly see at least 100 feet in front and to the sides of the tractor. Make sure you can clearly see bystanders, ditches, steep slopes, drop-offs, overhead obstructions, power lines, and debris or obstruction in the travel path. If you are unable to clearly see these types of items discontinue operating. Contact with unseen vehicles, bystanders, obstructions, or drop-offs can cause serious injury.

Be particularly careful in transport. The Implement has raised and moved the center of gravity to the front of the Power Unit increasing the possibility of overturn and tipping forward. Turn curves or go up slopes only at low speed and using a gradual turning angle. Go up slopes with the Implement located uphill. Slow down on rough or uneven surfaces.

(SPU-2)

 

1585 01/11

Safety Section 1-10

 

 

© 2011 Alamo Group Inc.

 

Image 14
Contents 1585 To the Owner/Operator/Dealer Table of Contents Maintenance Section Safety Section Safety General Safety Instructions and Practices1585 01/11 Safety Section Operator Safety Instructions and Practices Equipment Operation Safety Instructions and Practices SG-36 1585 01/11 Safety Section Safety Safety SL-33 Safety Safety Transporting Safety Instructions and Practices Maintenance and Service Safety Instructions and Practices Safety Storage and Parking Safety Instructions and Practices Concluding Safety Instructions and PracticesDecal Location QTY Level Description Decal Description Loader Positions 1585 01/11 Safety Section Loader Safety Safety Safety Federal Laws and Regulations Introduction Section Introduction Introduction Introduction Before Operating this Machine Page Assembly and Connecting the Loader Section Assembly Dismounting and Mounting Mid-Mount Loader1585 01/11 Assembly Section Proper Rear Ballasting and Wheel Spacing Dismounting the Loader Mounting Loader Installing Quick Attach Device Assembling Quick Attach DeviceConnecting the Attachment When Connecting an Attachment to the Loader Quick HitchPlumbing Hydraulic Valve Hose Plumbing Attaching Valve Mounting & ValveAttaching Tractor Hydraulic Block Plumbing Loader to Control Valve Page Operation Section Operation Standard Equipment and Specifications Operator Requirements Operation Personal Protective Equipment PPE Rops and Seat Belt Tractor RequirementsTractor Requirements and Capabilities Tractor Lighting and SMV EmblemTractor Ballast Getting On and Off the Tractor Boarding the TractorDismounting the Tractor Starting the Tractor Pre-Operation Inspection and Service Tractor Pre-Operation Inspection/ServiceLoader Pre-Operation Inspection/Service Mount Assembly OPS-L-0018A Do not Operate an Unsafe Tractor or Front END Loader Front END Loader PRE-OPERATION Inspection Driving the Tractor and Loader Brake and Differential Lock Setting Starting the TractorDriving the Tractor and Loader Operating the Tractor and LoaderSG-36 Operation 1585 01/11 Operation Section Operation Operation Operating the Loader Filling the BucketLifting the Load Carrying the Load Dumping the Bucket Operating with Float Control Operation Peeling and Scraping Loading LOW Trucks or Spreaders from a Pile Backfilling Operation Handling Large Heavy Objects Operating Bale Spear Optional Attachment Loader Storage Transporting the Tractor and Implement Operation Transporting on Public Roadways Hauling the Tractor and Implement Troubleshooting Guide Trouble Possible Cause Possible RemedyOperation Maintenance Section Maintenance 1585 01/11 Maintenance Section Lubrication Information Daily Checks Hydraulic CylinderLift and Bucket Cylinder Disassembly Lift and Bucket Cylinder ReassemblyStorage Maintenance Proper Torque for Fasteners Maintenance Maintenance Rhino To the OWNER/OPERATOR/DEALER SOM-01/11 F-4123C Printed U.S.A