WASHER
Assembly instructions
PRESSURE
Handle
Alignment 
Holes 
Frame
Assy.
Carriage
Bolt
Nut
Washer
Bolts | Hose/Spray Gun |
| Storage Bracket |
| Nut |
| Studs |
OPERATOR’S MANUAL
STEP 1: Attach the handle to the frame of the pressure washer. Note: It may be necessary to move the handle supports from side to side in order to align the handle so it will slide over the frame supports.
Spray
Gun
Safety
Latch
High Pressure
Hose
STEP 4: Attach the high pressure hose to the spray gun using teflon tape on hose threads.
STEP 2: Insert the carriage bolt through the holes from the outside of the unit and attach a nut from the inside of the machine. Tighten nuts.
Pressure |
Nozzle |
Wand |
Coupler |
STEP 5: Pull the
STEP 3: Attach the spray gun/hose storage handle, and bracket to handle. Tighten nuts.
Pressure | Wand Coupler | |
Nozzle |
| |
|
| |
| Wand Collar | |
STEP 6: Release the coupler collar and push the nozzle until the collar clicks. Pull the nozzle to make sure it is seated properly.
High Pressure Hose |
Coupler |
Collar |
Discharge |
Nipple |
STEP 7: Connect high pressure hose to pumps discharge nipple. Push coupler collar forward until secure.
Cold
Water
Source
Garden
Hose
STEP 8: Connect garden hose to the cold water source.
Garden
Hose
Pump
Water Inlet
STEP 9: Connect the garden hose to pump water inlet.
Inspect inlets. CAUTION: Do not run the pump with- out water or pump damage will result.